User manual PANASONIC U-6LE1E8

[. . . ] Each unit must be properly grounded with a ground (or earth) wire or through the supply wiring. The wires in this mains lead are colored in accordance with the following code: Green-and-Yellow: Earth Blue: Neutral Brown: Live As the colors of the wires in the mains lead of this appliance may not correspond with the colored markings identifying the terminals in your plugs, proceed as follows: The wire which is colored green and yellow must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or colored green or green-and-yellow. The wire which is colored blue must be connected to the terminal which is marked with letter N or colored black. The wire which is colored brown must be connected to the terminal which is marked with the letter L or colored red. [. . . ] The airflow direction cannot be set using the remote controller for any unit which is not listed below. • • • Never use your hands to move the flap (vertical airflow flap) that is controlled using the remote controller. When the air conditioner is turned off, the flap (vertical airflow flap) automatically moves to the downward position. The flap (vertical airflow flap) moves to the upward position when performing the standby operation for heating. The swing operation is made after the standby operation for heating is released, but swing is indicated on the remote controller even during the standby operation for heating. FLAP button is pressed during operation. Setting the airflow direction To activate the swing operation The airflow direction changes each time the Press the FLAP button to set the flap (vertical airflow flap) to the downward position, and then press the FLAP button again. Cooling and drying The flap (vertical airflow flap) can be set to one of three positions. Heating Set the flap (vertical airflow flap) to the downward position. When operating continuously in the fixed airflow direction setting for about an hour, the airflow direction is automatically controlled and the flap position is changed. The airflow direction may be different from the display on the remote controller. Zone ‘‘A’’ for cooling Zone ‘‘B’’ for heating Indoor unit Horizontal directions (manual) The horizontal airflow direction can be adjusted manually by moving the vertical vanes to the left or right. Concealed duct type (F1, M1, E1) This air conditioner is not equipped with air outlet parts. Please refer to the manual of the locally adopted air outlet parts. OI-141-7-EN 7 01_85464609141021_EN. fm Page 8 Thursday, August 11, 2011 11:24 AM Adjusting the Airflow Direction for Multiple Indoor Units Using a Single Remote Controller (Wired) • • Auto Flap ( ) button • The airflow direction cannot be set using the remote controller for the concealed duct type (F1, M1, E1) and floor standing type (P1, R1). If multiple indoor units are connected to a remote controller, the airflow direction can be set for each indoor unit by selecting the indoor units (see the operation below). Set the airflow direction for the indoor unit that is shown on the display. Each time UNIT is pressed, the indicator changes in the order shown below. When nothing is displayed, you can make the setting for all indoor units in one operation. The unit number is displayed as Outdoor Unit Number–Indoor Unit Number. 2–4 • • • One outdoor unit and eight indoor units No display Unit No. [. . . ] Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. [. . . ]