User manual PANASONIC ESL-V6N

[. . . ] Before operating this unit, please read these instructions completely and save them for future use. RO H SK CZ PL FIN S N P DK E NL I F D GB Warning • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. 6 • This WET/DRY shaver can be used for wet shaving using shaving lather or for dry shaving. [. . . ] €•The shaver can be used for approximately 2 weeks with a full charge. (Based on one 3-minute dry-shave use per day) The number of usable days varies depending on the following conditions. - Beard thickness - Pressure applied to the skin - Ambient temperature - Usage frequency of the sonic vibration cleaning mode ••If there is noise from radio or other source while using the shaver, move to a different location to use the shaver. How to use Shaving beard 1 Press ••The “shaving sensor”, which automatically adjusts the power depending on the beard thickness, will operate. It will shave with high power on areas where the beard is heavy, and reduce the power on areas where the beard is thin, to reduce burden on the skin. €•The power cannot be turned on when the switch lock lamp ( ) blinks, as the power switch is locked. Tips for better shaving Apply the whole system outer foil perpendicularly against the skin and shave by slowly gliding the shaver over the face against the grain of the beard. €•The beard under the chin and around the throat can be shaved better by stretching the skin so the beard will stand. €•To prevent damaging the system outer foil, do not shave with only a part of the system outer foil. 13 TR RO H SK CZ PL FIN S N P DK E NL I F D GB 2 Press when finished. After use While using ••The sonic vibration cleaning mode is activated when the power switch is pressed for more than 2 seconds while the shaver is not operating (the switch lock is unlocked). Locking/unlocking the power switch The used time and remaining battery capacity are shown and then turn off after 7 seconds. €•The shown time returns to [0’00”] after 10 minutes. The used time and remaining battery capacity blink alternately and then turn off after 8 seconds. When the battery capacity is low “10%” appears and “ ” blinks. €•The shaving sensor may not respond depending on the type and quantity of the shaving gel. €•Depending on the beard thickness or the amount of beard trimmings in the shaver head, the shaving sensor may not react and the driving sound may not change. €•To prevent erroneous operation, place your fingers on the finger rest while using the shaver. €•Do not move the short brush perpendicularly against the blades as it will damage the inner blades and affect their sharpness. It will keep the movement of the blade smooth and maintain a comfort shave. Switch off the shaver, and wipe off any excess oil from the system outer foil with a soft cloth. Notes ••Be careful not to hit the main body on the sink or any other object while draining the water. [. . . ] System outer foil and Replacement parts for inner blades System outer foil ES‑LV6N Inner blades WES9034 WES9175 WES9170 Battery life The life of the battery is 3 years. The battery in this shaver is not intended to be replaced by consumers. 20 Remove the built-in rechargeable battery before disposing of the shaver. Please make sure that the battery is disposed of at an officially designated location if there is one. [. . . ]