User manual PANASONIC CS-E18PKEA

[. . . ] Confirm with authorised dealer or specialist on usage of any specified refrigerant type. Using refrigerant type other than the specified may cause product damage, burst and injury etc. Do not install the unit in a potentially explosive or flammable atmosphere. Do not insert your fingers or other objects into the air conditioner indoor or outdoor unit, rotating parts may cause injury. [. . . ] CLOCK CANCEL CHECK AC RESET RC Press and hold for approximately 10 seconds to show temperature setting in °C or °F. Press and hold the button until you hear 1 beep, then release to use in forced COOL mode. Press and hold the button until you hear 2 beeps, then release to use in normal COOL mode. Press and hold the button until you hear 3 beeps, then release to use in forced HEAT mode. AUTO OFF/ON 6 To set the timer MODE To select operation mode Daily timer setting To turn ON or OFF the unit at a preset time. 1 2 TIMER/CLOCK MODE UP SELECT AUTO : For your convenience • Unit selects operation mode every 10 minutes according to setting temperature and room temperature. COOL : To enjoy cool air • Use curtains to screen off sunlight and outdoor heat to reduce power consumption during COOL mode. DRY : To dehumidify the environment • Unit operates at low fan speed to give a gentle cooling operation. OFF/ON DOWN SET 3 4 English How to use / To set the timer CLOCK CANCEL to enter timer mode 1 Press TIMER • Press once to change the display from clock to timer or vice-versa. € Press for 4 seconds to change the display from daily timer to weekly timer or viceversa. 2 Select ON or OFF timer Example: OFF at 22:00 OFF/ON MODE QUIET/ POWERFUL To switch between quiet & powerful POWERFUL NORMAL 3 Set the time UP DOWN QUIET QUIET: To enjoy quiet operation • This operation reduces airflow noise. POWERFUL: To reach temperature quickly • This operation will stop automatically after 20 minutes. € Can be activated in all modes and can be cancelled by pressing the respective button again. € When ON timer is set, the unit may start early before the actual set time in order to achieve the desired temperature on time. € Timer operation is based on the clock set in the remote control and repeats daily once set. € If timer is cancelled manually or due to power failure, you can restore the previous setting by pressing SET . note To adjust horizontal airflow direction • Manually adjustable. After timer is set, the TIMER indicator at indoor unit does not turn on, it does not indicate malfunction. [. . . ] POWER indicator blinks during HEAT mode • The unit is in defrost mode (and AIR SWING is set to with no warm air supply (and louver is closed). Indoor fan stops occasionally during heating • To avoid unintended cooling effect. POWER indicator blinks before the unit is • This is a preliminary step in preparation for the switched on. € Changes of temperature caused the expansion/ contraction of the unit. [. . . ]