User manual PANASONIC CS-E12CKP

[. . . ] Do not install, remove and reinstall the unit by yourself; improper installation will cause leakage, electric shock or fire. ⷠDo not wash the unit with water, benzene, thinner or scouring powder. ⷠDo not use for other purposes such as preservation of food. ⷠDo not use any combustible equipment in front of the airflow outlet. [. . . ] ⷠTurn off the power supply if the unit is not used for a long period of time. ⷠThis air conditioner is equipped with a built-in surge protective device. However, in order to further protect your air conditioner from being damaged by abnormally strong lightning activity, you may want to disconnect it from the power supply. Do not touch the air conditioner during lightning, it may cause electric shock. outdoor Unit · Do not sit, step or place anything on the unit. ⷠAfter long periods of use, make sure the installation rack is not damaged. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. ⷠThis equipment must be earthed and strongly recommended to be installed with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD). Otherwise, it may cause electrical shock or fire in case of malfunction. ⷠIn case of emergency or abnormal conditions (burnt smell, etc), turn off the power supply, and consult your nearest dealer. cOOL mode - To enjoy cool air DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. In heat mode, the air blows horizontally for a while, then starts to blow downwards and the airflow louvers start to swing left/right after the temperature rises. tO ENJOY CLEAN & FRESH AIR · Generates negative ions to produce fresh air effect and attract dust which will then be captured at the positively charged e-ion filters. When ON Timer is set, the unit may start earlier (up to 30 minutes) before the actual set time in order to achieve the desired temperature on time. If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is . Switched on with Press and hold for 5 seconds, then release to disable or restore this setting. , , and can be activated in all modes and can be cancelled by pressing the respective button again. And operations could be activated even when the air-conditioner is turned off. In this condition, once e-ion indicator is ON, the unit will operate with AUTO fan speed and air swing. [. . . ] Set the temperature 1°C higher in cool mode or 2°C lower in heat mode than the desired temperature to achieve a 10% power saving. Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode. ⷠDo not touch the aluminium fin, sharp parts may cause injury. hINTS · Clean the filter regularly for best performance and to reduce power consumption. [. . . ]