User manual PANASONIC CQ-VX777EW

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PANASONIC CQ-VX777EW. We hope that this PANASONIC CQ-VX777EW user guide will be useful to you.


PANASONIC CQ-VX777EW : Download the complete user guide (2513 Ko)

Manual abstract: user guide PANASONIC CQ-VX777EW

Detailed instructions for use are in the User's Guide.

[. . . ] The dashboard should be 4. 5 mm ­ 6 mm thick in order to be able to support the unit. 3 111. 6 mm 182 mm ¡Before installation, check the radio operation with antenna and speakers. ¡Disconnect the cable from the negative (­) battery terminal (see caution below). ¡The unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°. Installation Precautions This product should be installed by a professional installer, if possible. In case of difficulty, please consult your nearest authorized Panasonic Service Centre. [. . . ] This system is to be used only in a 12 V DC battery system (car) with negative ground. Failure to do so may result in damage to the unit. 0 ­ 30° 3. Be sure to connect the battery lead (yellow) to the positive terminal (+) of the battery or fuse block (BAT) terminal. Insulate all exposed wires to prevent short circuiting. Caution ¡Do not disconnect the battery terminals of a car with trip or navigational computer since all user settings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts. 6. Please carefully read the operating and installation instructions of the respective equipment before connecting it to this unit. 4 CQ-VX777EW Installation Hardware (For Installation) No. 1 <YFC054C091ZA> Transportation Bracket Removal Be sure to remove the transportation brackets before use (installation). (a page 7) Be careful not to lose these screws. Transportation Bracket w Mounting Collar 1 <YFX214C437ZA> e Lock Cancel Plate 2 <YFX994C134ZA> r Mounting Bolt (5 mmø) Round Head Screw t (5 mmø x 8 mm) Flat-Head Screw y (5 mmø x 8 mm) 1 <YEJV014C002N> Round Head Screw (5 mmø x 8 mm) 2 6 <ZZBISVD6505> Before Installation Caution ¡Do not press the panel forcefully. a Failure to observe the above may damage or break the glass on the surface of the touch panel. Installation Hardware (For Wiring) No. 1 <YAJ024C128CA> i ISO Antenna Adapter 1 <YEAA33144> Note: ¡The number in parenthesis underneath each accessory part name is the part number for maintenance and service. (a page 16) CAMERA IN (Yellow) S. W OUT (Black) Pre-Out Subwoofer connector (mono) To an external amplifier. 10 CQ-VX777EW Radio Antenna Connector (RADIO ANT IN) i ISO Antenna Adapter (If needed) System-up Connector To external devices equipped with system-up connector. u Power Connector To power connector of the unit. Side Brake (Parking Brake) Connection Lead (Bright green) Be sure to wire the side brake (parking brake) for safety and preventing accidents. External Remote Control Lead (Brown/black stripe) When using non-Panasonic external remote control, refer to the manufacture for their product before connecting. External Amplifier Control Power Lead (Blue/white stripe) To an external amplifier. Note: ¡Use the power control lead of the TV tuner for TV tuner connection. ¡Connect both the power control lead of the TV tuner and the amplifier control connector of the external amplifier when the TV tuner and external amplifier are connected at the same time. Speakers B8 : Rear Left ­ B7 : Rear Left + B6 : Front Left ­ B5 : Front Left + B4 : Front Right ­ B3 : Front Right + B2 : Rear Right ­ B1 : Rear Right + SIDE BRAKE Caution Reverse Lead (Violet/white stripe) When connecting the rear view camera, use the reverse lead. (a page 13) Not used. ACC A7 (Red) A5 (Blue) A8 (Black) BATTERY 15A ¡Use ungrounded speakers only. Allowable input : 50 W or more Impedance : 4 ­ 8 Use of speakers which do not match the specifications can cause burning, smoking or damage of the speakers. ¡Distance between speaker and amplifier: 30 cm or more ¡Do not connect more than one speaker to one set of speaker leads. (except for connecting to a tweeter) B5 B6 B7 B8 A7 : Power Lead (IGN or ACC) (Red) To ACC power, +12 V DC. [. . . ] (except for connecting to a tweeter) B5 B6 B7 B8 A7 : Power Lead (IGN or ACC) (Red) To ACC power, +12 V DC. A8 : Ground Lead (Black) To a clean, bare metallic part of the car chassis. This lead is not intended for use with a switch actuated power antenna. Note: ¡The power antenna extends automatically when the power of this unit is turned on. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PANASONIC CQ-VX777EW




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PANASONIC CQ-VX777EW will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.