User manual PANASONIC CQ-DF200W

[. . . ] Panasonic is not liable for any problems resulting from your own installation of the unit. First Time Power On This manual uses pictographs to show you how to use the product Label Indications and Their Locations CAUTION LASER RADIATION WHEN OPEN. DO NOT STARE INTO BEAM. CLASS 1 LASER PRODUCT ignition 1 Set your car'sACC or ON switch to the position. Note: If you would like to turn on the power and make the demonstration message appear, hold down [SRC] (PWR) for more than 4 seconds (ACC ON). VO L CQ-DF200W TUNE/TRACK ER LD FO D·M PWR PTY Warning SRC MUTE/SQ SCROLL RANDOM SCAN REPEAT TA/AF 1 2 3 4 5 6 DISP This pictograph intends to alert you to the presence of important operating instructions and installation instructions. Failure to heed the instructions may result in severe injury or death. Caution This pictograph intends to alert you to the presence of important operating instructions and installation instructions. [. . . ] If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection. This product utilizes a laser. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Caution Label CAUTION - LASER RADIATION WHEN OPEN. ATTENTION ­ RAYONNEMENT LASER SI OUVERT, ÉVITER TOUTE EXPOSITION AU FAISCEAU. UNDVIK ATT UTSÄTTAS FÖR STRÅLEN. (CQ-DF200WW) Warning Observe the following warnings when using this unit. Observe the following warnings when installing. Disconnect the lead from the negative (­) battery terminal before installation. Do not expose the unit to direct sunlight or excessive heat. Otherwise these will raise the interior temperature of the unit, and it may lead to smoke, fire, or other damage to the unit. Caution Be sure to select OFF when your car has no ACC position in the ignition switch. (a "Function Settings") The following functions are available. (Default: off) ¡ The power is turned on automatically when inserting a disc. Then open the hole from outside if possible. Installation Angle The product should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°. The user should bear in mind that in some areas there may be restrictions on how and where this unit must be installed. Consult your dealer for further details. 5 Press [DISP]. Minute blinks Do not use the unit when it is out of order. If the unit is out of order (no power, no sound) or in an abnormal state (has foreign objects in it, is exposed to water, is smoking, or smells), turn it off immediately and consult your dealer. Refer fuse replacement to qualified service personnel. When the fuse burns out, eliminate the cause and have it replaced with the fuse prescribed for this unit by a qualified service engineer. Incorrect replacement of the fuse may lead to smoke, fire, and damage to the product. Never install the product in a location where it interferes with your field of vision. Never have the power cord branched to supply other equipment with power. AM (LW/MW) mode: Band/frequency CT (Clock Time) FM (not RDS) mode: Band/frequency PS CT RDS mode: PS (Programme Service name) Band/frequency CT [SRC] (Source) selects a source. [u] (Eject) ejects the disc. BAND APM Radio Source Display Disc slot takes a disc in with the printed side facing up. Notes: ¡ The power will be turned on automatically when a disc is loaded at ACC ON. ¡ A disc which has both CD-DA data and MP3/WMA data on it may not be reproduced normally. [6] [7] skip to the previous/next track/file in the player mode. Hold down either of them for fast reverse/fast forward. CD-DA mode display Track number Play time Display change Press [DISP] to change the display. Disc Player (CD-DA disc): Disc Player (MP3/WMA disc): Normal Disc title Play Mode indicators Track title Normal Play time Folder name/ Album* File name/ Title, artist* Clock Player Source Display VO BAND APM L CQ-DF200W /TRAC K TUNE ER LD FO BAND VO L CQ-DF200W /TRAC K TUNE ER LD FO MP3/WMA mode display lights when folder random/repeat/scan is on. Folder number File number Clock D·M D·M PUSH SEL APM PUSH SEL PWR PTY PTY PWR SRC MUTE/SQ SCROLL RANDOM SCAN REPEAT TA/AF SRC MUTE/SQ SCROLL RANDOM SCAN REPEAT TA/AF 1 2 3 4 5 6 DISP 1 2 3 4 5 6 DISP /TRAC K TUNE [DISP] (Display) switches the information on the display. VO L CQ-DF200W PUSH SEL ER LD FO D·M *ID3/WMA Tag On/Off Hold down [3] for more than 2 seconds. Play Mode indicators album title and song title/ artist name are displayed. ¡ "NO TEXT" is displayed when there is no information on the disc. PWR PTY SRC MUTE/SQ SCROLL RANDOM SCAN REPEAT TA/AF 1 2 3 4 5 6 DISP [SRC] (Source) selects a source. (Hold it down for more than 1 second. ) [SRC] (Source) selects a source. [1] to [6] selects a preset station in the radio source, and presets the current station. (Hold it down for more than 2 seconds. ) [TUNE ]] [TUNE [] down/up the frequency. (Hold it down for more than 0. 5 seconds and release it for seek tuning. ) [DISP] (Display) switches the information on the display. [}] [{] skip to the previous/next folder. Power On/Off Set your car's ignition switch to the ACC or ON position. SQ (Sound Quality) SQ is a function that can call up various sound types at the touch of button in accordance with your listening music type. Power on: Press [SRC] (PWR). [. . . ] (a "Function Settings") PWR PTY PWR /TRAC K TUNE D·M PUSH SEL CQ-DF200W ER LD FO D·M PUSH SEL MUTE/SQ SCROLL RANDOM SCAN REPEAT PTY SRC TA/AF 1 2 3 4 5 6 DISP [DISP] (Display) exits from the audio menu. SRC MUTE/SQ SCROLL RANDOM SCAN REPEAT TA/AF 1 2 3 4 5 6 DISP [DISP] (Display) exits from the function menu. Trouble Check point Trouble Check point AF (Alternative Frequency) The following functions are available when the AF mode is active ( lights). Common Start the engine. (Or turn the ignition switch to the ACC position. ) Verify the wiring. (battery lead, power lead, ground lead, etc. ) Fuse blown (Contact the nearest Panasonic Service Centre. ) Ask a professional for fuse replacement. Wait until the dew disappears before turning on the unit. Radio Frequent noise Tune in to another station of high-intensity waves. [. . . ]