User manual OLYMPUS C-70 ZOOM

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Adjust or relocate the receiving antenna. - Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Only the OLYMPUS-supplied USB cable should be used to connect the camera to USB enabled personal computers (PC). [. . . ] Protecting the Power Cord -- The power supply cord should be placed so it will not be walked on. Never put a heavy object on the power cord or wrap it around the leg of a table or chair. Keep the area around the power cord connection points, at the power outlet, and at the product connection, free of all AC adapter or accessory power cords. Lightning -- If a lightning storm occurs while using a specified AC adapter, remove it from the wall outlet immediately. To avoid damage from unexpected power surges, always unplug the AC adapter from the power outlet and disconnect it from the camera when the camera is not in use. Overloading -- Never overload wall outlets, extension cords, power strips, or other power connection points with too many plugs. Foreign Objects, Liquid Spillage -- To avoid personal injury caused by fire or electrical shock from contact with internal high voltage points, never insert a metal object into the product. Heat -- Never use or store this product near any heat source such as a radiator, heat register, stove, or any type of equipment or appliance that generates heat, including stereo amplifiers. Attempting to remove the covers or disassemble the product, could expose you to dangerous high voltage points. En 7 d4228_basic_e_00_bookfile_7. book Page 8 Tuesday, August 17, 2004 1:42 PM Safety Precautions Damage Requiring Service -- If you notice any of the conditions described below while using a specified AC adapter, unplug it from the wall outlet and refer servicing to qualified service personnel: a) Liquid has been spilled onto the product or some other object has fallen into the product. c) The product does not operate normally despite following operating instructions. Adjust only the controls described in the operating instructions as improper adjustment of other controls could damage the product and require extensive repair work by a qualified technician. Replacement Parts -- When replacement parts are required, make sure that the service center uses only parts with the same characteristics as the originals, as recommended by the manufacturer. Unauthorized substitution of parts could result in fire, electrical shock, or create other hazards. Safety Check -- Upon completion of servicing or repairs, ask the service technician to perform safety checks to determine that the product is in good working order. En Legal and other notices · Olympus makes no representations or warranties regarding any damages, or benefit expected by using this unit lawfully, or any request from a third person, which are caused by the inappropriate use of this product. Attach the strap correctly as shown above so that the camera does not fall off. If the strap is attached incorrectly and the camera falls off, Olympus is not responsible for any damages. 11 d4228_basic_e_00_bookfile_7. book Page 12 Tuesday, August 17, 2004 1:42 PM CHARGING THE BATTERY The battery is not fully charged at the time of purchase. Charge the battery fully with the LI-10C charger before use. 1 Connect the power cable. LI-10C battery charger Power cable AC wall outlet En 2 Insert the battery into the charger. mark LI-12B lithium ion battery Charging indicator When charging starts, the indicator lights red. When fully charged, the indicator turns green. TIPS The LI-12B battery takes approximately 120 minutes to charge. Note This camera uses an Olympus LI-12B/LI-10B lithium ion battery. The charger can be used within the range of AC100V to AC240V (50/60Hz). When using the charger abroad, you may need a plug adapter to convert the plug to the shape of the AC wall outlet. Do not use voltage converters sold in stores traveling overseas as this could damage your charger. 12 d4228_basic_e_00_bookfile_7. book Page 13 Tuesday, August 17, 2004 1:42 PM INSERTING THE BATTERY AND CARD 1 Make sure the camera is off. The lens is retracted. The monitor is off. Battery compartment/card cover 2 3 Open the battery compartment/card cover. En Slide Lift Insert the battery. To remove the battery Slide the lock knob as shown. The battery pops up allowing you to grasp it. Battery lock knob The battery is locked into place when inserted correctly. Battery lock knob 13 d4228_basic_e_00_bookfile_7. book Page 14 Tuesday, August 17, 2004 1:42 PM INSERTING THE BATTERY AND CARD 4 Insert the card. Contacts Notch Make sure that the card is oriented correctly and insert while keeping it straight, otherwise the contacts on the card may be damaged or the card may get stuck. En To remove the card Push the card all the way in and release slowly. [. . . ] The lens retracts. 2 Close the flash. Push the flash into the camera. En Now that you have mastered how to shoot and play, check out the Advanced Manual for more camera applications. . . . And for extra enjoyment, install OLYMPUS Master image editing software on the supplied CD-ROM. 21 d4228_basic_e_00_bookfile_7. book Page 22 Monday, August 23, 2004 10:23 AM Specifications Camera Product type Recording system Still picture : Digital recording, TIFF (non-compression), JPEG (in accordance with Design rule for Camera File system (DCF)), RAW data : Digital camera (for shooting and displaying) Applicable standards : Exif 2. 2, Digital Print Order Format (DPOF), PRINT Image Matching II, PictBridge Sound with still pictures : Wave format Movie Memory Resolution : QuickTime Motion JPEG support : xD-Picture Card (16 ­ 512 MB) : 3, 072 × 2, 304 pixels(RAW/TIFF/SHQ/HQ) 3, 072 × 2, 048 pixels(3:2 SHQ/HQ) 2, 592 × 1, 944 pixels(SQ1) 2, 288 × 1, 712 pixels(SQ1) 2, 048 × 1, 536 pixels(SQ1) 1, 600 × 1, 200 pixels(SQ1) 1, 280 × 960 pixels (SQ2) 1, 024 × 768 pixels (SQ2) 640 × 480 pixels (SQ2) : Approx. 331 frames : 7, 100, 000 pixels : 1/1. 8" CCD solid-state image pickup, 7, 410, 000 pixels (gross) : Olympus lens 7. 9 mm to 39. 5 mm, f2. 8 to f4. 8 (equivalent to 38 mm to 190 mm lens on a 35 mm camera) : Digital ESP metering, spot metering system : f2. 8 to f8. 0 : 15 to 1/2000 sec. : 0. 6 m (2. 0 ft. ) to ) (W), 1. 2 m (3. 9 ft. ) to ) (T) (NORMAL) 8 cm (0. 3 ft. ) to ) (W), 0. 6 m (2. 0 ft. ) to ) (T) (macro mode) : Optical real image viewfinder : 2. 0" TFT color LCD display, 206, 000 pixels : TTL system autofocus Contrast Detection Method : DC-IN jack, USB connector (Multi-connector), A/V OUT jack (Multi-connector) (RAW (TIFF (SHQ (HQ (SQ1 (SQ2 : 3, 072 × 2, 304) : 3, 072 × 2, 304) : 3, 072 × 2, 304) : 3, 072 × 2, 304) : 1, 600 × 1, 200 NORMAL) : 640 × 480 NORMAL) En No. [. . . ]