User manual MOULTRIE 135 GAMESPY

[. . . ] If this equipment does interfere radio or television reception , the user is encouraged to correct the interference by the following steps: Reorient the antenna of the radio or television Relocate the computer to match the radio or television receiver Plug the computer into a different power outlet If necessary, the user should consult with the dealer or an experienced radio/television technician for help and suggestions. The user may find the following booklet, prepared by the FCC, helpful in solving radio/television interference problems: "How to Identify and Resolve Radio-TV Interference Problems" This booklet is available by sending a written request to: U. S. Government Printing Office Washington D. C. , 20402 Request Stock Number 004-000-0345-4. ECC Statement This device complies with the requirements of EEC directive 89/336/EEC with regard to Electromagnetic Compatibility. Dieses Greät entspricht den Anforderungen der EEC-Richtlinie 89/336/EEC für elektromagnetische Verträglichkeit. [. . . ] If this product was acquired outside the United States or its Territories, then local law may apply. If you live in Canada, any other nations in Central & South America, including the Falkland Islands, or the United States, its Territories, and its Commonwealths, and you have questions regarding this EULA, please contact MOULTRIE at this address: MOULTRIE, Inc. 51 Discovery, Suite 100 Irvine, CA 92618, USA. If you live in any nation that is not located in the areas as listed above, please contact MOULTRIE Int'l. 5-1 Innovation Road I/Science-Based Industrial Park/Hsin-Chu 300/Taiwan, R. O. C. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL MOULTRIE OR ITS SUPPLIERS BE LIABLE FOR ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, DAMAGE TO COMPUTER SOFTWARE OR HARDWARE, OR ANY OTHER PECUNIARY LOSS) ARISING OUT OF THE USE OF, INABILITY TO USE THE SOFTWARE PRODUCT OR THE PROVISION OF, FAILURE TO PROVIDE SUPPORT SERVICES, OR INABILITY TO INSTALL THE HARDWARE PRODUCT, EVEN IF MOULTRIE HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES AND JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY, THE ABOVE LIMITATION MAY NOT APPLY TO YOU. @n IP Company Contents Checklist 1. PenCam VoiceRecorder 2. Application / One Driver CD Driver & Application 3. Install Quick Guide 4. USB Cable NOTE: If you are missing any of these contents please inform your dealer or your nearest support office so that the contents can be replaced. Ins ta ic Qu l uid kG e System Requirements Microsoft Windows X P / 98 / ME / 2000 Pentium 200 MHz (or equivalent) processor or higher 32 MB of RAM (64 MB recommended) Video card with 2 MB of RAM for minimum 16 bit (High Color) display Audio Card (recommended) 4X speed CD-ROM An available USB port Specifications Sensor type: Color VGA(640x480) CMOS image sensor Image Performance for Video Stream: 9 fps for QVGA(320x240 Pixels) 3 fps for VGA(640x480 Pixels) Internal Memory : 64 Mbit SDRAM Images Capacity : 26 Picture for VGA(640x480 Pixels), 107 Pictures for QVGA(320x240 Pixels) Maximum audio recording: 13 minutes (without image capture) Sound Quality: 10KHz sample rate Dimension:5. 5"x2. 2"x0. 7" Battery: AAA1. 5V x2 battery Lens view angle: 54 Degrees Interface type: USB Port Software Support: Microsoft Windows X P / 98/ME/2000 @n IP Company Operating Environment 41-104 Fahrenheit ; 5-40 Celsius 20% - 85% relative humidity, non-condensing Warning!Remove dust or stains with a soft cloth dampened with water or neutral detergent. Do not use any volatile chemicals or liquids such as thinner or benzene to clean your camera. . Do not attempt to disassemble your camera. How to Use Your PenCam VoiceRecorder Introduction The built-in memory of your camera is 64 Mbit memory. It supports 13-minute voice recording and two kinds of resolution- high resolution ( 640x480 VGA) for 26 pictures and low resolution ( 320x240 QVGA ) for 107 pictures. Besides, your camera offers several functions on the LCD, showing the remaining number of pictures as well. = Press the "DSC Function" button to change the camera to DSC & Camcorder mode. Live View (PC Camera Mode) DSC Function (DSC Mode) @n IP Company PC Camera Mode It is easy to attach your camera to your system. The current view is displayed in the "preview" window. Live preview PC Camera Mode = Press "Video Source" button to adjust advanced settings. capture an = Press "Record button" to record a video clip to album window. DSC Mode Transferring Photos & Voice: This allows you to transfer photos in your camera. < Press the "Link" button to connect the camera and transfer photos & sounds. > Press the "Transfer all" or "Transfer selected" button to transfer photos or sounds to the album window. = Transfer pictures and sounds in your camera to your PC. Open or close album window = Transfer selected photos and sound to album window = Transfer all photos and sound to album window @n IP Company Enhanced Resolution Mode: . Optical Resolution: VGA ( 300K pixels) Your camera has particular enhanced image skills, which make images sharper by enhancing the original VGA image to XGA image. You can download your images again. Playing picture or voice: You can play any picture file you want in the browser or in the album window by double clicking the picture icon to execute your default media application. This button allows user to select any image and voice files and convert them into an AVI file. This AVI file is transferred to your album window. Image/Audio Sync. Editing Photos: It is easy to edit any photo you want in the album window. Double click the photo icon to execute your default image application (such as Imaging, Paint. . . . etc. ) to edit your image file. @n IP Company Uploading Video: After transferring images to the preview window, click AVI Creator and all images are combined in one AVI file. [. . . ] MOULTRIE Technical Support is limited to helping the End-User with installation of the HARDWARE PRODUCT only. MOULTRIE Technical Support will not provide support for software provided by MOULTRIE's suppliers that was included with the HARDWARE PRODUCT, nor will MOULTRIE Technical Support provide assistance and/or training in use of the software provided by MOULTRIE's suppliers. Any attempt by the end user to disassemble any part of the HARDWARE PRODUCT, decompile any part of the software included with the HARDWARE PRODUCT, or damage any piece of the HARDWARE PRODUCT (including but not limited to accidental damage, incidental damage, purposeful damage, or damage caused by a person other than the End-User), shall immediately and irrevocably void the Limited Warranty. MOULTRIE shall then be released from honoring any and all parts of this Limited Warranty, and the End-User will be ineligible for both the Warranty Service, and will also be ineligible for receiving Technical Support. [. . . ]