User manual MINOURA P-700X

[. . . ] If not, adjust the length of the Adjusting Screw then tighten the lock nut firmly by a 13mm spanner. [. . . ] This is very important to keep enough stability while your bike is on the stand. 3 Assemble the clamp jaw unit to the Upper Pillar. The Back Knob should be tightened as firmly as possible until the clamp jaws rotates smoothly. 13mm spanner 4 Insert the assembled Upper Pillar into the Lower Frame until the bottom cut-outs catch the Upper Pillar Holding Bolt, then tighten the Lock Bolt firmly by a 5mm hex wrench. To install the optional Tool Tray, insert the tray into the Upper Pillar BEFORE assembling the frames. Minoura does not owe any responsibility to any extra troubles these problems may bring. For more detail, refer the attached "MINOURA LIMITED WARRANTY POLICY" card in the package. Phone: 1-510-538-8599 Fax: 1-510-538-5899 Email: support@minourausa. com MINOURA JAPAN HEADQUARTERS (for all other customers) 1197-1 Godo, Anpachi, Gifu 503-2305 Japan Fax: 81-584-27-7505 Email: minoura@minoura. jp Web: www. minoura. jp MADE IN JAPAN P-700X / SMALL PARTS LIST C-4 C-11 C-3 C-6 C-7 P-4 P-3 C-9 C-10 C-4 C-8 P-1 C-11 T-4 T-2 C-3: C-4: C-6: C-7: C-8: C-9: C-10: C-11: P-1: P-3: P-4: P-5: P-7: P-8: P-9: L-3: L-4: L-9: L-10: L-11: T-2: T-4: Clamp Rubber Lock Clip Clamp Shaft Clutch Packing Clamp Space Collar M8 Flat Washer Back Knob Clamp Jaws Assy Upper Pillar Clutch Release Lever Pivot Screw Pillar Cap Upper Pillar Holding Bolt & Nut Lock Bolt Lower Frame Leg End Cap Adjusting Screw Left Side Leg Right Side Leg M8x40 Bolt & M8 Nylon Nut Tray Fixing Knob Bolt Tool Tray w/ tool slots L-3 L-4 L-10 L-3 L-4 L-9 L-11 L-11 P-7 P-9 P-7 P-5 P-8 [. . . ] For more detail, refer the attached "MINOURA LIMITED WARRANTY POLICY" card in the package. [. . . ]