User manual MAXI-COSI RODI XR

[. . . ] Dear parents Congratulations on your purchase of the Maxi-Cosi Rodi XR. Safety, comfort and user-friendliness played an important role throughout all stages of development of the Maxi-Cosi Rodi XR. the Maxi-Cosi Rodi XR is optimised for side impact protection and extra user-friendliness. The features that provide this protection are located primarily in the back and headrest. [. . . ] We recommend using the Maxi-Cosi Rodi XR for children weighing at least 15 kg and tall enough that the shoulder belt rests against their shoulder, not their neck. The points along which the car seat belt should be threaded are marked in red. There is a red-marked opening under the armrests on the seat (lap belt) and red-marked belt hooks on the headrest (shoulder belt). Attaching and removing the backrest with the seat Place the backrest of the Maxi-Cosi Rodi XR on a flat surface with the front facing downward (2). Next, slide the seat at around a 50° angle into the hooks at the bottom of the backrest as shown in illustrations 2 and 3 (3). Push the seat downwards and under the backrest until they form a seat. The hooks on the lumbar supports will now fall into the openings in the armrests. continue pushing the backrest until you hear a "click" (4). The Maxi-Cosi Rodi XR can be disassembled by carrying out these instructions in reverse order. Grab hold of the headrest with one hand on top so that your fingers fit into the positioning handle. Squeeze the positioning handle and pull up on the headrest while pushing against the backrest with your other hand (5, 1/5, 2). ⷠOnce you have reached the desired height, release the positioning handle, thereby allowing it to click into the right position. The "Placing your child in the Maxi-Cosi Rodi XR" section describes how to determine the correct height of the headrest for your child. Adjusting the position of the shoulder supports The shoulder supports on the Maxi-Cosi Rodi XR can be adjusted into 2 different positions, depending on the size of the child. Grab hold of the shoulder supports and pull or push them into the desired position (6). We only recommend folding out the shoulder supports on the Maxi-Cosi Rodi XR if the space between the shoulders of the child and the shoulder supports is smaller on both sides than the thickness of your hand. This could be caused by thicker or thinner clothing or the fact that the child has grown. Installing the Maxi-Cosi Rodi XR in a car using the anchor Adjust the headrest on the passenger seat into the highest position. Place the anchor between the 2 bars of the headrest on the passenger seat (7). Once the anchor has been secured, both headrests can be adjusted into the desired positions. [. . . ] ⷠPull the cover out from under the rim of the plastic belt guides (14, 3) and then pull it forward from the back across the armrests (14, 4). ⷠThe cover should now be fully removed from the booster seat. ⷠRemove the cover from the hooks on the inside of the backrest (16, 2). ageing of the plastic , for instance under the influence of sunlight (UV) , may quite unnoticeably reduce the qualities of the product. [. . . ]