User manual MAXDATA USB-PARALLEL CABLE

[. . . ] In addition, do not expose the server to any temperatures over +30 °C or under +10 °C. Make sure that the cables connecting the server to peripheral devices are not tight. Feature NIC 2 activity LED NIC 1 activity LED Power/Sleep button Power/Sleep LED Function Continuous green light indicates a link between the system and the network to which it is connected. Random blinking green light indicates hard disk drive activity (SCSI or SATA). [. . . ] With the black lever in the fully open position, slide the drive carrier into the chassis. Do not push on the black lever until the lever begins to close by itself. NOTE For proper airflow, the hard drive carrier must be replaced in the chassis, even if no hard drive is installed in it. When the black lever begins to close by itself, push on it to lock the drive carrier into place. 24 Hardware Installations and Upgrades Removing and Installing the PCI Riser Assembly Always operate your server chassis with the PCI riser assembly in place. You will need to remove the PCI riser assembly from the chassis to replace the PCI riser connectors, or to add or remove a PCI add-in card. Removing the PCI Riser Assembly Use the following instructions to remove the PCI riser assembly from the chassis. Power down the server and unplug all peripheral devices and the AC power cable. Lift up on the two levers on the PCI riser assembly to lift the riser assembly from the chassis. Removing PCI Riser Assembly from the Server System Installing the PCI Riser Assembly 1. Power down the server and unplug all peripheral devices and the AC power cable. See your add-in card documentation for information and add-in card requirements. Set the riser assembly straight down, matching the hooks in the back of the riser assembly to the notches in the rear of the chassis. Install the chassis cover. MAXDATA Server PLATINUM 1500 IR M6 25 Installing a PCI Add-in Card 1. Set the heat sink over the processor, lining up the four captive screws with the four posts surrounding the processor. Loosely screw in the captive screws on the heat sink corners in a diagonal manner. Gradually and equally tighten each captive screw until all screws are tight. MAXDATA Server PLATINUM 1500 IR M6 29 5. Reinstall and reconnect any parts you removed or disconnected to reach the processor sockets. Replace the server's cover and reconnect the AC power cord. TP00774 Figure 24. Twist the heat sink slightly to break the seal between the heat sink and the processor. If installing a replacement processor, see "Installing the Processor. " Otherwise, install the protective socket cover over the empty processor socket and reinstall the chassis cover. 30 Hardware Installations and Upgrades RJ45 Serial Port Configuration The RJ45 serial port connector can be configured to support either a DSR signal or a DCD signal. As the server board is shipped, it is configured to support DSR signals. To change the configuration to support DCD signals a jumper on the board must be changed. Use the following instructions to configure your server board to support DCD signals. Move the jumper from the default position covering pins 3 and 4 to cover pins 1 and 2. J8A3 Figure 25. [. . . ] If on-board video is bing used, the server board may be faulty. 8 In addition to the beep codes above, additional beep codes are provided if an Remote Management Module is installed. The Remote Management Modules provide the following additional beep codes. Table 8. Error Beep Codes Provided by Remote Management Modules Beep Code 1 1-5-1-1 1-5-2-1 1-5-2-3 Reason for the beeps and action to take Control panel CMOS clear has been initiated. Power control failure. 1-5-2-4 1-5-4-2 1-5-4-3 1-5-4-4 40 Troubleshooting 7 Technical Reference Power Supply Specifications 600 W Single Power Supply Input Voltages · · 100-127 V at 50/60 Hz; 8. 55 A max. [. . . ]