User manual LYNX 4VT340ND

[. . . ] 9000 252 511 (8609) Instructions for use en Index 4 5 6 7 8 9 11 13 Washing dishes . . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Warning For safety reasons, if the appliance is not fitted in a recess, thereby making a side wall accessible, the door hinge area should be covered at the side. (Risk of injury) Covers are available as optional accessories from customer services or specialist stores. Installation Install and connect the appliance according to the installation and assembly instructions. [. . . ] This programme will be performed unless another programme button 8 is pressed. The programme starts automatically. 14 en Programme interruption Carefully open the door, it could happen that water splashes out of the appliance. If the programme is already in "drying" mode, an acoustic signal reminds you to close the appliance door or to abort the programme. If warm water is connected or if the machine is already heated up and the appliance door has been opened, leave the door slightly ajar, then close it, otherwise the appliance door can jump open through the expansion. In order to continue the programme flow, switch the main switch ON again and close the door. Additional functions * on some models additional functions 3 can be set with the buttons. Saving time (VarioSpeed) * The Save time function can reduce the running time by approx. To obtain optimum cleaning and drying results at a reduced running time, water and energy consumption are increased. Half load* If you have only a few items to wash (e. g. The "half load" additional function saves water, energy and time. It is recommended to put a little less detergent in the detergent dispenser than for a full load. Cancel programme (Reset) Only when the master switch is ON. Press the A and C programme buttons simultaneously and hold them pressed for approx. The PROGRAMME END indicator and the indicator for the programme that has just been terminated light up. To restart the dishwasher, set main switch 1 to ON again and select desired programme. Changing the programme It is possible to change the programme selection after you have switched the dishwasher on, provided that you have not yet closed the door. If it is necessary to change the programme after this, the programme cycle that has already begun (e. g. 15 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Filters The filters 25 prevent large particles of food in the water from reaching the pump. When the appliance has finished washing, check the filters for particles of food and, if required, clean. After undoing the coarse micro-filter, the filter unit can be removed. Remove any particles of food and rinse the filters under running water. Insert the filter unit and tighten the coarse micro-filter. Overall condition of the machine Check washing chamber for grease and limescale deposits. If you find such deposits: Fill the detergent dispenser with detergent, start the appliance without utensils in the programme which has the highest wash temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly wipe the front of the appliance and panel with a damp cloth; water and a little washing-up liquid will suffice. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. [. . . ] If the appliance is not kept upright during transport, any water left inside may seep into the control module and cause subsequent errors with programme functions. The appliance must be drained in the following sequence: Turn on the tap. Turn off the tap. Electrical connection Connect the appliance only to 230 V alternating current via a correctly installed socket with protective conductor. The socket must be attached near the dishwasher and be freely accessible. [. . . ]