User manual LUX WH263

[. . . ] CLASSIC INSTALLATION AND INSTRUCTION MANUAL PEMASANGAN DAN BUKU PETUNJUK WASHING MACHINE MESIN CUCI WH263 WH263 GB 147143600 ID Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. Contents Warnings Disposal Tips for environmental protection Technical specifications Installation Unpacking Positioning and levelling Water inlet Water drainage Electrical connection 3 4 4 4 5 5 5 5-6 6 6 Washing hints Sorting the laundry Temperatures Before loading the laundry Maximum loads Laundry weights Removing stains Detergents and additives International wash code symbols Operating sequence Programme tables 10 10 10 10 10 10 10-11 11 12 13-14 15-16 Maintenance Bodywork Door seal Detergent dispenser drawer Drain pump Water inlet filter Emergency emptying out Frost precautions 17 17 17 17 17-18 18 18 18 Your new washing machine Description of the appliance Detergent dispenser drawer 7 7 7 Use Control panel Controls 8-9 8 8-9 Something not working? 19-20 The symbols you will see on some paragraphs of this booklet have the following meaning: The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. [. . . ] Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. Before loading the laundry Never wash whites and coloureds together. New coloured items may run in the first wash; they should therefore be washed separately the first time. Rub particularly soiled areas with a special detergent or detergent paste. Remove hooks or tie them up in a bag or net. Maximum loads Recommended loads are indicated in the programme charts. General rules: Cotton, linen: drum full but not too tightly packed; Synthetics: drum no more than half full; Delicate fabrics, hand wash and woollens: drum no more than one third full. Washing a maximum load makes the most efficient use of water and energy. 10 Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. Do not machine wash garments saturated with petroleum, methylated spirits, trichlorethylene, etc, If such fluids have been used to remove stains prior to washing, wait until they have completely evaporated from the fabric before placing garments in the appliance. (*) do not use acetone on artificial silk. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Not enough washing powder causes: ­ the wash load to turn grey, ­ greasy clothes. [. . . ] By doing this, any water remaining in the machine is removed, avoiding the formation of ice and, consequently, breakage of the affected parts. When you use the machine again, make sure that the ambient temperature is above 0°C. Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO valve avoiding that part of the detergent remains unused at next washing. Water inlet filter If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked. [. . . ]