User manual LIFT-MASTER 65LM

[. . . ] If possible, install keyless entry system on left side of garage (determented by facing garage from outside). If installed on right side of garage, cable must be routed over or under console. FEATURES OF THE OF KEYLESS ENTRY SYSTEM Personalized Code: 10, 000 possible combinations. Operation: Opener activates when programmed code is entered on the keyboard. [. . . ] In darkness this feature allows user to press any number before entering the 4-digit code. IMPORTANT NOTE: When Illumination is needed, avoid pressing keyboard area which contains the first code number. STEP 1--ONE-PIECE DOORS: Install the keyboard on the exterior front wall of a FRAME garage. Position it away from the door opening to avoid injury as door swings out and up. Refer to note below; then proceed to Step 2. Garage Exterior Door Jamb Edge PARTS LIST Console Assembl . . Model 95 NOTE: If garage Is constructed of material other than wood (brick, stone or aluminum siding), install keyboard on door jamb with this important exception: Locate keyboard on outside edge of door jamb to avoid injury as door swings out and up. NO USER SERVICEABLE PARTS. For service Information call Toll Free: 1-800-528-2817 NOTE: If your garage has a built up jamb, drill the hole 2" deep. Then, on inside edge of jamb, drill a second hole into first hole to complete access. 1/8" Pilot Hole 1" Dia. Hole 2" Deep Cable 6ABx1-1/4" Screw Door Opening Inside Garage Wall Inside Edge of Jamb STEP 4: Position console on an interior garage wall approximately one foot from outside edge of door. Run bell wire up wall and across ceiling to garage door opener terminals. On current line Chamberlain models, connect wire to red and white opener terminals. Snap a 9 volt battery onto circuit board connector and drop into console. DO NOT replace panel at this time. STEP 2: Hold keyboard firmly with the back of the case UP. Keyboard will lift out of cover, allowing access to bottom mounting hole. Excess cable can be folded and inserted into the access hole to keep it out of the way. Console Front Panel Console Push Button Program/Operate Switch Bell Wire Transformer Terminals 3 2 1 Bell Wire (To Garage Door Opener) Connector Guides PRO GRA M E OPE RAT Batte ry Console Terminals Transformer Model 95 To 120V Outlet Cable STEP 3: Connect the 2-strand bell wire to terminals labeled 1 and 2 on back of console. IMPORTANT: Some garage door openers have a third screw terminal which supplies power to the radio control. [. . . ] NOTE: If you have Installed Transformer Model 95, plug the transformer Into a 120 VOLT outlet. If the door operates properly, replace the front panel on the console. Loss of power to either the battery or the garage door opener will not affect the programmed code. [. . . ]