User manual LENCO DVP-722

[. . . ] 6. Number Buttons (0, 1, . . . , 9) 7. 10+ Button Uses to input 10 to 999 (combining this button and other digit number buttons). ENTER/DIRECTION Buttons 9. SETUP Button Brings up the setup MENU to set up the system's language, audio, display, password etc. 10. SKIP FORWARD ( )Button Use to skip to next title, chapter or track. 11. SKIP BACKWARD ( ) Button Use to skip to previous title, chapter or track. [. . . ] Using the battery pack under 0 C (32 F) or over 40 C(104 F) can cause reduced battery life. x 5 14 Playing a Disc Turning ON /OFF the player To Turn On The Player 1. Slide POWER on the Player to ON, this will put the Player on standby mode. 3. You can also press STANDBY on the remote control to turn on the power. To put the Player on standby mode Press STANDBY on the remote control. To Turn Off The Power Slide POWER on the Player to OFF. Preparation for Playback 1. Make sure the unit has the power either from the battery pack or the AC adaptor. 2. Loading a disc, following these steps: Open the top cover by pushing the latch to the right and lift the top cover. You can also press PLAY ( ) on the Player to turn on. PLAY/PAUSE Press on the Player or PLAY/ PAUSE ( ) on the remote control to start play. STOP Press once to stop playback. 5 15 Playing a Disc Resume This Player provides a unique resume function for making viewing movie more convenient. Follow these steps 1. When you want to interrupt the playback and come back later to play where you interrupted it, you can press OPEN on the Player to open the disc compartment cover. 2. You can now turn off the power, put it on standby, or even remove the disc from the Player, and when you play the same disc next time, the disc will play from where it was interrupted. Skip You can skip chapters on DVD-Video, tracks on CDs, and Video CDs. 1. To skip forward, press during play or while paused; it skips to the next chapter or track. 2. To skip to previous chapter or track, press . Fast Forward and Reverse 1. During playback, to fast forward, repeatedly press 2. During playback, to fast rewind, repeatedly press 3. To resume normal playback, press . to increase the fast reverse speed 2x , 4x , 8x , 20x. Slow Motion 1. During playback, repeatedly press SLOW to play at 1/2, 1/3, 1/4, 1/5, 1/6, 1/7 speeds. You can only perform slow motion play in the forward direction. Frame-by-Frame Playback 1. During playback, press on the Player to pause. 3. To resume normal playback, press on the Player or You can only perform step play in the forward direction. 5 16 on the remote control. Playing a Disc Repeat Playback You can play a chapter, a track, a title, a file or the entire disc repeatedly. 2. To cancel repeat playback, repeatedly press REPEAT until " REP:[ OFF ] " appears on the screen. Mark (Bookmark) The Mark function lets you select parts of a DVD so that you can quickly find the section at a later time. Follow these steps to set up marker playback: 1. During playback, press MARK on the remote control. 3. When you reach the scene you want to mark, pres ENTER to confirm; and the underscore changes to a number (1, 2, 3, 4 or 5 ). You can perform marker playback at any time by press MARK, and using i ng to select one of the marks, then pre sing on s the Player to start playing the book marked scene. Repeat the above to play the other marked scenes. GOTO You can go directly to a desired chapter and play, or play at a desired point of time. Press GOTO, use to select title (TT) and chap ter (CH) and enter the desir ed number. Press GOTO, repeatedly press to move to the time display and it changes 00:00:00. Press ENTER to confirm and start play. 5 17 Playing a Disc ZOOM 1. Press ZOOM repeatedly during playback or pause to enlarge (2X, 3x, 4x, ) or reduce (1/2, 1/3, 1/4) the image. [. . . ] If not, recharge it. Check that the battery is inserted in the "+" and "-" directions properly. Check that the signal transmission is directed at the remote control senor on the DVD player. Contact the service center for lens cleaning. Disc does not play No picture No picture and sound Check if the LCD on/off switch is stuck, and cannot move freely when the top cover is open. With power turned on, slide INPUT/OUTPUT once. No sound Check the volume setting. [. . . ]