User manual LA CROSSE TECHNOLOGY WS9117

[. . . ] If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1. In order to ensure sufficient 868 MHz transmission however, the distance between the Temperature Station and the transmitter should not be more than 100 meters (see notes on "Positioning" and "868 MHz Reception"). 50 WHEN MORE THAN ONE TRANSMITTER IS USED 1. User shall remove all the batteries from the Temperatuire Station and transmitters and wait 60 seconds. [. . . ] Ensure that the batteries used are new of from the correct size. 58 Please help in the preservation of the environment and return used batteries to an authorized depot. 59 LCD SCREEN The Temperature Station's LCD is split into 3 sections and once the batteries are inserted, all the segments will light up momentarily before displaying : 1. Time "0:00" Indoor and outdoor temperature in degree Celsius (°C) or Fahrenheit (°F) 60 Time Indoor Temperature in °C or °F Outdoor Temperature in ºC or °F Transmitter identification No. Outdoor Transmission Signal* 61 *When the signal is successfully received by the Temperature Station, the outdoor transmission icon will be switched on. (If not successful, the icon will not be shown on LCD) So the user can easily see whether the last reception was successful (icon on) or not (icon off). On the other hand, the short blinking of the icon shows that a reception is currently taking place. 12 or 24 hour setting: After the batteries are inserted, set the time display as follow : 1. Press and hold the "SET/CH" key for about 3 seconds to enter the set mode 62 2. 3. 4. Either a ": 12h" or ": 24h" will appear on the LCD. If ": 12h" is displayed then the current time display is set to 12-hour time. If ": 24h" is displayed then the current time is set to 24-hour time. To alternate between the two times display mode, simply press the "MIN/MAX/+" key. When the desired time display is selected, press the "SET/CH" key once more to enter the Celsius or Fahrenheit degree setting mode. Note : When the time display is set to 12-hour mode, the temperature unit will be fixed to °F; when the selected time mode is 24-hour, the temperature unit will be fixed to °C. 63 CELSIUS OR FAHRENHEIT DEGREE SETTING: Following from the 12 or 24 hour setting mode. Either a "°C" or "°F" will appear on the LCD. If "°C" is displayed then the current temperature reading is set to Celsius. If "°F" is displayed then the current temperature reading is set to Fahrenheit. Press "SET/CH" key to confirm and enter the time setting mode. TIME SETTING : Following from the Celsius or Fahrenheit degree mode. 64 1. 2. 3. The Hour digit in the time section starts flashing Using the "MIN/MAX/+" key, to set the hours of the current time and then followed by pressing the "SET/CH" key to advance to the minute mode Again, using the "MIN/MAX/+" key, to set the minutes of the current time and then finally followed by pressing the "SET/CH" key to exit the setting mode. [. . . ] Please contact your local or/and regional authorities to retrieve the addresses of legal dumping grounds with selective collection. 82 · · · All electronic instruments must from now on be recycled. User shall take an active part in the reuse, recycling and recovery of the electrical and electronic waste. The unrestricted disposal of electronic waste may do harm on public health and the quality of environment. [. . . ]