User manual LA CROSSE TECHNOLOGY WS-9133U-IT-CA

[. . . ] To change between "12h" and "24h" press and release the "MIN/MAX" button. 6 b. When you have your choice shown on the display press and release the "SET" button once. 2. 3. Degree Fahrenheit will now show. To change between Fahrenheit and Celsius, press and release the "MIN/MAX" button. When you have your choice shown on the display press and release the "SET" button once. [. . . ] Press and release the "MIN/MAX" button to select either 12h time (am/pm) or 24h time 3. Press and release the "SET" button 2 times, the hour will flash in the upper left corner. Press and release the "SET" button to move to the minute setting 6. Press and release the "SET" button to activate the clock. 11 Note: When in 12h mode, there is only a "PM" display, which appears under "TIME. " If there is no display here it is AM. Press and hold the "SET" button for 5 second until "12h" or "24h" appears in the TIME LCD. Press and release the "SET" button again, "°F" will appear in the TIME LCD. Press and release the "MIN/MAX" button to shift between °F and °C. Press and release the "SET" button twice to activate settings. 12 IV. Press and release the "MIN/MAX" button, "MIN" appears in the temperature LCD's and the recorded minimum temperatures are displayed. Press and release the "MIN/MAX" button to toggle to the maximum temperatures. The time of occurrence of the value for outdoor temperature will also flash. B. If you wish to use the table-stand, all that is required is to place the indoor temperature station in an appropriate location. a) Fix a screw (not included) into the desired wall, and place the indoor 17 temperature station onto the screw using the hanging hole on the backside. Gently pull the indoor temperature station down to lock the screw into place. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The LCD is faint Solution: Replace batteries Problem: No outdoor temperature is displayed. Solution: 1) Remove all batteries, reinsert into remote temperature sensor first, and then into the indoor temperature station. 2) Place remote temperature sensor closer to the indoor temperature station. 3) Be sure all batteries are fresh. 18 4) Place remote temperature sensor and indoor temperature station in position so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. Solution: Each temperature sensor is manufactured to be accurate to within 1 degree plus or minus and under normal conditions; so two temperature sensors could be as much as 2 degrees different. However, the difference can be exaggerated further because the temperature sensors are designed for different working environments. The indoor sensor is less responsive to ambient air currents because of the shielding effect of the display's case. [. . . ] Station: Outdoor (-29. 9°C to 69. 0°C with 0. 1°C resolution) Temp accuracy +/- 1°F (+/- . 5°C) Transmitting Maximum 80 feet (25m) range open space Temperature check Indoor Every 10 seconds Outdoor Three times in 10 minutes Batteries--(Alkaline recommended) 2 x AA, 1. 5V Remote Temperature Sensor 21 Indoor Temperature Station 2 x AAA, 1. 5V Dimensions: (L x W x H) Indoor 2. 36 x 0. 88 x 5. 90 in. Sensor Battery life Approximately 1 year WARRANTY INFORMATION La Crosse Technology provides a 1-year warranty on this weather station. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the weather station in for repairs, contact La Crosse Technology. [. . . ]