User manual LA CROSSE TECHNOLOGY WS-8011UM-TWC

[. . . ] For more information about WWVB please see the NIST website at http://www. boulder. nist. gov/timefreq/stations/wwvb. htm QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. Place the batteries into the remote temperature sensor first then into the temperature clock. (All remote temperature sensors must be started before the temperature clock) DO NOT PRESS ANY BUTTONS FOR 10 MINUTES. 4. In this time the temperature clock and remote temperature sensor will start to talk to each other and the temperature clock will show both the indoor temperature and an outdoor temperature. If the temperature clock does not display both temperatures after the 10 minutes please retry the set up as stated above. [. . . ] E) TIME SETTING Note: When the WWVB signal is found, that time will over-ride the manually set time. 1) Hold down the "SET" button for 2 seconds (the selected time zone will flash). 2) Press and release the "SET" button 3 times until the hour "12" flashes in the time LCD. 6 3) Press and release the "+" button to select the hour. Note: when setting the hour, "PM" will appear to the left of the hour display, if it is AM nothing will be displayed. 4) Press and release the "SET" button to confirm the hour setting, and to shift to select the minutes. 6) Press and release the "SET" button to confirm the time setting and to advance to manually set the calendar. F) CALENDAR SETTING Note: When the WWVB signal is found, that date will over-ride the manually set date. 1) Hold down the "SET" button for 2 seconds (the selected time zone will flash). 2) Press and release the "SET" button 5 times until the default year "00" flashes in the date LCD. 4) Press and release the "SET" button to confirm the year, and to set the month. 6) Press and release the "+" button to select the appropriate month. 7) Press and release the "SET" button to confirm the month and to set the date. 9) Press and release the "+" button to select the appropriate date. 10) Press and release the "SET" button to confirm the date and to set the weekday. 11) The default weekday "MON" (depends on selected language) will flash. 12) Press and release the "+" button to select the appropriate weekday. 13) Press and release the "SET" button to confirm the calendar settings and to advance to select either 12 or 24-hour time display. G) 12/24-HOUR SETTING Note: 12-hour uses AM/PM, 24-hour is also known as "military" time. 1) Hold down the "SET" button for 2 seconds (the selected time zone will flash). 2) Press and release the "SET" button 9 times until the "12" hour time display flashes in the time LCD. 3) Press and release the "+" button to toggle between 12 and 24 hour time. 4) Press and release the "SET" button to confirm the 12/24-hour time display and to advance to select either °F or °C. 7 H) SELECTING °F OR °C 1) Hold down the "SET" button for 2 seconds (the selected time zone will flash). [. . . ] Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the temperature clock in for repairs, contact La Crosse Technology. The temperature clock will be repaired or replaced with the same or similar model. This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the clocks inability to receive a signal due to any source of interference. [. . . ]