User manual LA CROSSE TECHNOLOGY WS-7047U

[. . . ] Any walls that the signal will have to pass through will reduce distance. An outdoor wall or window will have 20 to 30 feet of resistance and an interior wall will have 10 to 20 feet of resistance. NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up of your indoor weather station after the 10 minutes have passed please follow the steps on pages 4 to 6. 3 DETAILED SET-UP GUIDE FOR THE WIRELESS WEATHER STATION I) Battery Installation Note: Batteries will fit tightly. [. . . ] Place the 3 tabs (on the rainfall collector) into the tab slots (on the base) and turn counter-clockwise. II) The Remote Temperature Sensor 5 The remote temperature sensor can be mounted in two ways: · with the use of screws · using the adhesive tape A. Through the three screw holes of the bracket, mark the mounting surface with a pencil. With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. Adhere the tape to the designated area on the back of the mounting bracket. Position the remote temperature sensor in the desired location, ensuring that the indoor temperature station can receive the signal. III) The Indoor Weather Station The indoor weather station can be mounted in two ways: · with the table stand · on the wall with the use of a wall hanging screw (not included). Using the Table Stand The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand all that is required is to place the indoor weather station in an appropriate location. Fix a screw (not included) into the desired wall leaving approximately 3/16 of an inch (5mm) extended from the wall. Place the indoor temperature station onto the screw using the hanging hole on the backside. Gently pull the station down to lock the screw into place. 6 OPERATION OF THE WIRELESS WEATHER STATION A) Viewing the Temperature (Remote and Indoor) 1. The indoor temperature will display in the Temperature portion of the LCD. To View the remote temperature press and release the "RESET" button. Press and release the "RESET" button to return to the indoor temperature. B) Viewing the Rainfall 1. The rainfall total will be displayed in the Rainfall portion of the LCD. To reset the rainfall total to 0. 00 press and hold the "RESET" button for 3 seconds. TROUBLESHOOTING NOTE: For problems not solved please contact RadioShack. Problem: The LCD is faint 7 Solution: Replace batteries Problem: No outdoor temperature is displayed. Remove all batteries, reinsert into remote rain sensor first, then into the remote temperature sensor and then into the indoor temperature station. Place remote temperature sensor and indoor weather station in a position so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. Solution: Each temperature sensor is manufactured to be accurate to within 1 degree plus or minus and under normal conditions; so two sensors could be as much as 2 degrees different. However, the difference can be exaggerated further because the sensors are designed for different working environments. [. . . ] To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. 9 La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. [. . . ]