User manual LA CROSSE TECHNOLOGY TX29U-IT

[. . . ] If this does not happen after 5 minute, the batteries will need to be removed from all the units and reset from step 1. Insert the batteries to the third transmitter as soon as the "channel 2" icon and outdoor data are displayed on the temperature station. Then within 5 minutes, the channel 3 outdoor data from the third transmitter will be displayed and the channel icon will shift back to "1" once the third transmitter is successfully received. If this is not happen, user shall restart the setting up from step 1. INVENTORY OF CONTENTS 1. [. . . ] After the batteries have been installed, the indoor temperature station will search for the signal for a duration of few minutes. If there is no temperature reading in the OUTDOOR LCD after 5 minutes, user shall make sure the units are within range of each other, or repeat the battery installation procedure. If a button is pressed before the indoor temperature station receives the signal from the Temperature transmitter, you will need to follow the battery installation procedure again. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free). The batteries will fit tightly (to avoid start-up problems make sure they do not spring free). Note: · · · If the signal reception is not successful on the first frequency of 915MHz for 45 seconds, the frequency is changed to 920MHz and the learning is tried for another 45 seconds. If it is still not successful the reception is tried for 45 seconds on 910MHz. Detailed Set up procedures of the Temperature Station and the Transmitter refer to the main operation manual of WS-9021U or 9640U. MOUNTING THE TEMPERATURE TRANSMITTER The Temperature transmitter can be mounted onto a wall with the use of screws MOUNTING WITH SCREWS SETTING UP When one transmitter is to be used 1. First, insert the batteries to the temperature transmitter (see "Battery Installation" below). Within 2 minutes of powering up the transmitter, insert the batteries to the Temperature Station (see "Battery Installation" below). Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature and the time as 12:00 will be displayed. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. After the batteries are inserted, the Temperature Station will start receiving data signal from the transmitter. The outdoor temperature should then be displayed on the Temperature station. If this does not happen after 5 minutes, the batteries will need to be removed from both units and reset from step 1. In order to ensure sufficient 915 MHz transmission however, there should be a distance of no more than 330 feet (100 meters) between the final position of the Temperature Station and the transmitter. Adding additional remote transmitters (using more than 1 transmitter) 1. Through the two screw holes of the bracket, mark the mounting surface with a pencil. Insert the Temperature transmitter into the bracket. 1 Table standing With the mounting bracket installed at the bottom, the transmitter can be placed on any flat surface. the cost of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or performance variations resulting from installation-related circumstances. LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. [. . . ] Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. [. . . ]