User manual KENWOOD KRC-953 SERVICE MANUAL

[. . . ] Do not subject the faceplate to excessive shock, as it is a piece of precision equipment. When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong rating may cause your unit to malfunction. To prevent short circuits when replacing a fuse, first disconnect the wiring harness. [. . . ] Wiping the faceplate with a hard cloth or using a volatile liquid such as thinner or alcohol may scratch the surface or erases characters. Characters in the LCD may become difficult to read in temperatures below 41 °F (5 °C). The illustrations of the display and the panel appearing in this manual are examples used to explain more clearly how the controls are used. Therefore, what appears on the display in the illustrations may differ from what appears on the display on the actual equipment, and some of the illustrations on the display may represent something impossible in actual operation. Turning OFF the Power Press the [PWR OFF] button for at least 1 second. When the dB(Sound Coordinate) setting is changed, the Bass and Treble set in audio control replace the dB(Sound Coordinate) values. Each time the button is pressed for at least 1 second the Loudness turns ON or OFF. Each time the button is pressed the items that can be adjusted switch as shown below. You can recall the best sound setting preset for different types of the music. Adjustment Item Bass level Treble level Balance Fader The faceplate of the unit can be detached and taken with you, helping to deter theft. The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. Insulate unconnected wires with vinyl tape or other similar material. To prevent short circuits, also do not remove the caps on the ends of the unconnected wires or the terminals. The unit may receive damage or fail to work if you share the - wires and/or ground them to any metal part in the car. After the unit is installed, check whether the brake lamps, indicators, wipers, etc. If the console has a lid, make sure to install the unit so that the faceplate does not hit the lid when closing and opening. Battery wire (Yellow) 6 Ignition wire (Red) 7 If no connections are made, do not let the wire come out from the tab. 18 Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type ANT CONT antenna. 12) The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit. the default connection for the wiring harness is described in 1 below. If the ISO connector pins are set as described in 2 or 3, make the connection as illustrated. [. . . ] to link the unit's power to the ignition , connect the ignition cable (ACC. Red) to a power source that can be turned on and off with the ignition key. Engage the catch pins on the removal tool and remove the two locks on the lower level. Insert the two removal tools deeply into the slots on each side, as shown. [. . . ]