User manual JVC XV-S40
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JVC XV-S40. We hope that this JVC XV-S40 user guide will be useful to you.
Manual abstract: user guide JVC XV-S40
Detailed instructions for use are in the User's Guide.
[. . . ] DVD VIDEO PLAYER
XV-S40BK/XV-S42SL XV-E100SL
Introduction
2
Preliminary knowledge
5
Getting started
13
Basic operations
17
OPEN /CLOSE
STANDBY/ON
PLAY MODE
3D PHONIC CANCEL RETURN
Advanced operations
20
1 4 7 10
2 5 8 0
3 6 9 +10
THEATER POSITION
ANGLE SUBTITLE AUDIO
DIGEST
ZOOM
PREVIOU
S
4 7
¢
SELECT
NEXT
CLEAR
3
STROBE
8
SLOW+
SLOW
1
E
¡
TITL
MEN
U
DVD/CD PLAYER
STANDBY
Initial settings
OPEN/CLOSE
35
5 5 5 ENTER
CH OIC E DISP LAY
STANDBY ON
0 4
DOLBY
DIGITAL
DVD/VIDEO CD/CD
SKIP
¢
STOP
PLAY
PAUSE
7
3
8
RM-SXVB40A REMOTE CONTROL
Additional information
42
INSTRUCTIONS
For Customer Use: Enter below the Model No. Serial No
LET0178-005A [B]
Warnings, Cautions and Others
IMPORTANT for the U. K. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. [. . . ] Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other accidents.
Warning
Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents. T prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If the o cord is damaged, contact a dealer and get the new power cord. Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.
Getting started
To install batteries in the remote control unit
The battery compartment is located on the back of the remote control unit.
Press down on the point shown by the arrow at the top of the compartment cover, and pull up the cover to open the compartment.
Place the two accessory R6P (SUM-3)/AA(15F) batteries in the remote control according to the polarity markings (+ and ) inside the compartment and on the batteries.
!
Place the cover over the compartment, and press down lightly.
The batteries will last about six months with normal use. If the functions of the remote control become erratic, replace the batteries. See below for more information.
Precautions for the safe use of batteries
Observe the following precautions for the safe use of batteries. If they are used improperly their life will be shortened, they may burst or their contents may leak.
Precaution
Remove the batteries from the remote control if it is not going to be used for a long period of time. Never leave dead batteries lying around, take them apart, mix them with other refuse, or throw them into an incinerator. Do not mix new and old batteries, or batteries of different types, when replacing them.
$
Basic operations
In the following description, the buttons on the remote control unit are mainly used, however, you may use the corresponding buttons on the front panel of the unit if available.
English English English
Turning on/off the unit
Press STANDBY/ON on the remote control unit or press on the front panel.
DVD/CD PLAYER
STANDBY
OPEN/CLOSE
OPEN /CLOSE
STANDBY/ON
STANDBY ON
0 4
DOLBY
DIGITAL
DVD/VIDEO CD/CD
PLAY MODE
3D PHONIC CANCEL RETURN
STANDBY/ON
SKIP
¢
STOP
PLAY
PAUSE
7
3
8
1 4 7 10
2 5 8 0
3 6 9 +10
THEATER
You can turn on the unit by pressing the
operation, the unit starts playback if the disc is set in the disc tray. You can turn on the unit by pressing the button on the front panel.
!
button. In this
(OPEN/CLOSE)
Even if you press the STANDBY/ON
or
button to turn off the unit, the unit is not disconnected from the AC power
source as long as it is connected to the wall outlet. In this state, the unit consumes a very small amount of power.
Inserting and removing discs
1 Press0 (OPEN/CLOSE) to open the disc tray. 2 Place the disc in the tray.
With the label side up
O CD VIDE DVD
CD
OP
EN/
CLO
SE PLA STO P Y
SE PAU
8
0
P
3
0 -S3 XV
ER AY D PL DV
4
SKI
¢
7
ANG
LE
1
D. MIX K CHAP TRAC GRO UP TITLE
A-B
VCD
VD
LPCM RAM MPEGY PROG OM DOLBAL RAND DIGIT DTS
· To insert an 8-cm disc, place it in the inner recess.
STA
NDB
Y
STA
ND
BY
ON
D IG
BY DOL A L
IT
3 Press 0 (OPEN/CLOSE) located on the right of the disc tray
If you press
(OPEN/CLOSE) for the disc being played, the unit stops playback and opens the tray.
NOTES
The unit can playback DVD VIDEO, Audio CD, and Video CD discs only. When loading a disc in the tray, be sure to position the disc inside the recess. Otherwise, the disc may be damaged when the tray is closed, and the disc may not be removed from the unit.
%
Basic operations
NOTE
Basic operations
Basic playback
Now you can play a disc. First, lets enjoy simple playback according to following procedure.
To start playback
Press 3.
The unit starts playback from the begining.
NOTES
When the resume point is memorized, pressing of the beginning.
!
starts playback from that point instead
DIGEST ZOOM
During playback, the display window shows the title/chapter or track number being played.
US PREVIO
4 7
¢
SELECT
NEXT
CLEAR
3
STROBE
8
SLOW+
With Video CD discs with PBC control or some DVD discs, the menu display may appear on the TV screen after starting playback. For operation using a menu, see page 20.
SLOW
1
¡
Basic control buttons
With some DVD discs, the unit starts playback automatically after inserting the disc.
.
Basic operations
To stop playback completely
Press 7.
The unit stops playback.
To stop playback temporarily
Press 8.
The unit pauses playback. To resume playback, press
.
!.
7Duri
To advance or reverse playback rapidly while monitoring
ng playback
From the Remote control unit Press 1 or Á.
Each press of normal speed. Pressing
From the Front panel
Holding down
1orÁi 3returnstheuni
ncreases the playback speed. You can select the speed among 2x, 5x, 10x, 20x and 60x the
t to normal playback.
Hold down 4 or ¢.
from 5x to 20x the normal speed if you keep holding down the button for a certain period of time. Releasing the button returns the unit to normal playback.
¢advancespl
ayback rapidly, while holding down
4reversespl
ayback. [. . . ] Please go through the following list before requesting service.
English English English
Symptom
Power does not come on.
Possible case
Power plug is not inserted securely.
Remedy
Plug in securely.
Too far from the unit.
More closer to the unit.
The tip of the remote unit is not pointed in the right direction. Batteries are exhausted.
Point the infrared light- emitting window toward the remote sensor on the front panel.
Replace the batteries with new ones.
Battery polarity is incorrect.
Take out the batteries and insert them again in the correct direction.
Connection of video cable is incorrect. No picture is displayed on the monitor.
Connect the cable correctly.
Input selection of TV is incorrect.
Select correctly.
Disc is not playable.
Use a playable disc. (See page 12. )
Picture is not normal when using the S-VIDEO jack.
The unit is set to feed the RGB signals (instead of the S-video signals).
Make the unit feed the S-video signals (See page 14).
Picture is noisy.
The unit is connected to a VCR directly and the copyguard function is activated.
Connect the unit so that the picture signal flows directly to the TV.
Connection is incorrect. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JVC XV-S40
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JVC XV-S40 will begin.