User manual JUNO JSI4360S

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. s s Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] Place it in the cutlery basket separate from the others. UI04 34 PBA01GB The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the fold-down cup racks so that water can reach all surfaces. Long-stem glasses can then be suspended from the prongs of the cup racks. Larger plates (dinner plates up to 24 cm in diameter) must be loaded in the front part of the upper basket. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. Before closing the door, ensure that the spray arms can rotate freely. ENGLISH US17 IEC 436 / DIN 44990 US32 Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. RC01 A After loading your machine always close the door, as an open door can be a hazard. 35 PBA16GB Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see Programme Chart on the following pages), so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. glasses and crockery (except pots) so that you may re-use them promptly. ** This is a special programme for quick washing (approx. Leave the door ajar to prevent the formation of any unpleasant smells; 4. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Avoid over tilting the machine during transport. 40 PMC02GB Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. Symptom The machine will not start Solution s s s s The door has not been properly closed. Dishes are rattling against each other, (refer to "Loading your machine"). The dishes have been left too long inside the machine. The dishwasher does not fill with water s s s s The filters are blocked The spray arms are not rotating The dishwasher will not drain s s s s s s The machine is noisy s s The door is difficult to close The dishes are not clean (poor wash) s s s s s s s s s s s Visible lime deposits or white film on the dishes The dishes are not quite dry s s s 41 PSN01GB ENGLISH If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. This information can be found on the rating plate located on the right hand side of the dishwasher door (see picture). ENGLISH Protection against flooding In order to prevent water floods, the machine has been provided with two additional devices, having the following characteristics: 1. In the water inlet hose (see Water supply connections): the device comes into operation as a result of any damage to the water inlet hose and stops the water inflow. In the bottom of the machine: the device comes into operation as a result of any water leaks in the machine and it functions only with the machine on. . . . . . . . . RA01 Service and spare parts This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] Directives: - 73/23 of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 45 min 30 cm max 100 cm min 30 cm max 100 cm PWA04GB ENGLISH Building-in This dishwasher is designed to be fitted under a kitchen counter or worksurface. It is essential that the recess dimensions indicated in the diagram are followed. ENGLISH No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor since the dishwasher incorporates adjustable feet (max 60 mm). A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. Adjusting the height of the appliance To adjust the height proceed as follows: 1. [. . . ]