User manual JUNO JSI4360B

[. . . ] . page 56 ENGLISH TECHNICAL SPECIFICATIONS DIMENSIONS Width Height Max depth Max depth with door open 59, 6 cm 81, 8 ÷ 87, 8 cm 57, 5 cm 115 cm ELECTRICAL CONNECTION POWER OF HEATING ELEMENT OVERALL POWER Voltage 220-230 V/50Hz 1900 W 2100 W WATER SUPPLY PRESSURE minimum maximum 5 N/cm2 80 N/cm2 12 CAPACITY (STANDARD IEC PLACE SETTINGS) CONSUMPTION: Water Electricity 22 lt 1. 5 kW/h This appliance complies with the following E. E. C. Directives: - 73/23 of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. PID02GB 44 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. You MUST read them carefully before installing or using the appliance. s s Under no circumstances should you attempt to repair the machine yourself. [. . . ] The dishwasher is equipped with a softener which uses special dishwasher salt to provide lime-free (softened) water. The softener can treat water hardness up to 90 French degrees via 5 adjustment levels. Find on the table below the level corresponding to the hardness of your water and the required adjustments: Water hardness °dH German degrees °TH French degrees Level Use of salt Water softener adjustment Adjustment on the machine Levels 4 and 5 (adjustment on the machine) If your water is level 4 or 5, open the door and drill membrane (A) on the upper left-hand corner of the machine. A AA04 With a water hardness of level 5 both adjustments must be made. Important Salt MUST be used regularly from level 2 upward. Filling with Salt Only use salt designed specifically for use in dishwashers. Other types of salt contain high percentages of other substances which may reduce the efficiency of the softener. Fill the container with 1 litre of water (this operation is necessary only the first time). Place approximately 1, 5 ÷ 1, 8 kg of dishwasher salt inside using the funnel provided (see figure). LE SA LT SA LZ SA L SE ENGLISH 0- 7 8-21 22-28 29-39 40-50 0-14 15-39 40-50 51-70 71-90 1 *2 3 4 5 **NO YES YES YES YES NO NO YES NO YES NO NO NO YES YES * The water softener is factory set at level 2 as this suits most users. ** If you use phosphate free detergents containing enzymes, use salt starting from 4°dH (7°TH). Level 1 If your water is «level 1» it is already soft and therefore there is no need to use salt. Levels 3 and 5 (water softener adjustment) If your water is level 3 or 5, proceed as follows: slide out the lower basket and unscrew the cap of the salt container; turn the twoposition selector anticlockwise from position - to position + with the aid of a knife or a screwdriver. AA02 SR09 Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. When this has been done, all that is required is to periodically add salt to the container. You are reminded of this by a green refill indicator on the cap of the salt container. When the green indicator disappears, the water softener needs refilling with salt. Note: When buying new dishes, ensure that they are dishwasher-proof. To Save Energy Do not prewash dishes under running water. Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see Programme Chart on the following pages), so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. PCL02GB 51 ENGLISH ENGLISH Washing programmes Recommended quantity of detergent Programmes Required Starting pushposition button of the programmer in the dispenser on the door on the dispenser lid 1/2 Cycle description Approximate consumption values *** Type of load Degree of soil Energy Water Programme consumption consumption duration in kWh in litres in minutes * Normal Programme 65° Normally or heavily soiled, also dried up and/or containing Pots - Pans starch (i. e. Crockery 3 (20 g) (5 g) 2 level dessert spoons dessert spoon Cold prewash Main wash up to 65°C 2 cold rinses 1 hot rinse up to 65°C Hot air drying 80 1, 5 22 ** Quick Programme 65° Crockery, cutlery Lightly soiled, not dried up (i. e. Due to the shortness of this programme, no drying phase is provided. 1 / / (15 g) 1 heaped dessert spoon Main wash up to 65°C 1 cold rinse 1 hot rinse up to 65°C 50 1, 4 18 PTP02GB 52 Rinse & Hold Partial load to be completed later. This programme does not require any detergent. 2 / 1 cold rinse (to avoid food scraps from sticking to the crockery). 10 0, 1 14 * This programme is equivalent to IEC 436/DIN44990. Recommended quantity of detergent: 20 g in the dispenser 5 g over the dispenser lid Standard place settings: 12 ** This is a special programme for quick washing (approx. 50 minutes) a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. Due to the shortness of this programme, no drying phase is provided. These *** also onspecifications are indicative values and depend on the pressure and temperature of the water, and voltage modification. Operating Sequence 1 Check that the filters are clean (see cleaning instructions) 6 Start the programme Insert the plug into the wall socket. The «mains on» indicator light will come on and the machine will start. 2 Check that there is salt and rinse aid If you wish to interrupt the wash at any time press button again. To restart the machine, depress the same button again and the programme will continue from the point where it was interrupted. 3 Load the dishes Remove larger scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. [. . . ] The sink drain is blocked. There is no air vent in the end of the drain hose. The dishes are not clean (poor wash) s s s s s The baskets are too full. The water inlet funnel in the centre of the upper basket is covered by dishes. . . . . . . . . RA01 s s s s s s s PRA17GB 55 ENGLISH The drain hose extension is not correct. If, after the above checks, the fault persists, call your nearest Service Centre, indicating the fault, the appliance model (Mod. ), the product number (Prod. This information can be found on the rating plate located on the righthand side of the dishwasher door (see picture). BUILDING-IN Building-in features This dishwasher is designed to be fitted under a kitchen counter or sink. [. . . ]