User manual JUNO JDS2230B

[. . . ] Fit the carbon filter on its proper housing, first on the upper hooks then, using two locking keys D, on the lower hooks (Fig. 5) must be fitted on the hole B fixing it with the special screws provided. -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. [. . . ] -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. The use of an unprotected flame is dangerous for the filters and could cause fires. When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please , keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. -- The air is purified through an active carbon filter and returned to the room. -- The use of an active carbon filter is necessary when an exhaust pipe to the exterior is not available, or when it is not possible to install this type of pipe. The angle frame has one long arm and one short arm, to be used in alternative depending on the depth of the cupboards. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. To get best efficiency, we suggest to use slow speeds in normal conditions and the highest in particular cases of strong smell and vapour concentration. Use the intensive speed switch only in case of high concentration of vapour. The switching plate is fitted with two switches: one for the adjustment of the ventilator and one for illuminating the work surface . Note: Simply close the front panel to switch off the hood (light and motor). When you pull up the front panel, the hood (light and extraction motor) switches on again as previously set. It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. [. . . ] Note: Simply close the front panel to switch off the hood (light and motor). When you pull up the front panel, the hood (light and extraction motor) switches on again as previously set. It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. [. . . ]