User manual JUNO JDK9940S

[. . . ] Motor speed buttons speed 1 (d. ), speed 2 (e. ), speed 3 (f. ) Control panel with keypad. Electronic control panel A A­ B­ E­ F­ C­ D­ G­ H­ I­ I B EFCD G H Motor OFF button On button and motor speed selection button 1 - 2 - 3 - 1 - 2 - . Speed 1 LED Speed 2 LED and metal grease filter saturation LED (flashes) Speed 3 LED and carbon filter saturation LED (flashes) Intensive speed LED Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. ). [. . . ] Hood with electronic control panel The carbon filter should be replaced every 6 months under normal use and anyhow whenever the carbon filter saturation led indicates the saturation of the filter. Once you have replaced the carbon filter, press button A and button B together for about two seconds (see page 10) until you hear the acoustic signal (beep). N. B. : the carbon filter saturation led will also flash even if the hood is used in the exhausting version (i. e. To stop the led flashing, press the two buttons A and B as described above. Fit the carbon filter into its housing, by pushing it backwards and then forwards and fixing it with the two red buttons B on the carbon filter. 3: To dismount the carbon filter, press the two buttons B and pull downwards . Replacing the lamp - Fig. Fit the new lamp ensuring that the two male contacts of the lamp fit perfectly into the female contacts of the lamp holder. -- If the lighting is not operating, remember to check that the lamps are fitted correctly before calling your technician. -- -- -- -- Warning! -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. The use of an unprotected flame is dangerous for the filters and could cause fires. When frying foods, never leave the pan alone because the cooking oil could flare up. [. . . ] If you intend to connect it directly to the electric mains, remove the plug and fit an approved bipolar switch with a minimum contact opening of no less than 3mm. If the plug is not accessible once it has been inserted in the socket, it will however be necessary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm. [. . . ]