User manual HOOVER U5140 GIUDE

[. . . ] · Do not use to pick up flammable or combustible materials such as gasoline or fine wood sandings or use in areas where they may be present. · Always turn off this appliance before connecting or disconnecting hose. Empty bag frequently when picking up very fine materials such as powder. Do not use with any opening blocked; keep free of dust, lint, hair, or anything that may reduce air flow. [. . . ] Also, turn cleaner OFF before disconnecting and connecting hose to hose tube (A). When you are finished cleaning with the tools, be sure to lift cover from hose tube and reposition hose end into tube. Select proper tool C. Dusting brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters, and registers. Furniture nozzle may be used for upholstered furniture, draperies, mattresses, clothing, automobile interiors, and carpeted stairs. Crevice tool may be used in tight spaces, corners and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards. Crevice wand (included on some models) may be used for the same tasks as the crevice tool is used. It can also be used for extra reach with the dusting brush and/or extension wand. How to clean tools To clean the hose, wipe off dirt with a cloth dampened in a mild detergent. Rinse and air dry before using. Continued § 7 2-15 Extra reach hose (available at additional cost) The extra reach hose provides you with a 20 foot reach to allow easier cleaning of stairs and hard to reach places. Follow the steps below for attaching and detaching hose. 2-17 H 2-16 J Attach wand and tools Attach tool or wand or crevice wand (some models) to the hose (H) by pushing it firmly into hose. Twist wand or tool slightly to tighten or loosen the connection. I J Push ON/OFF switch to OFF position and unplug from electrical outlet. Align end of extra reach hose with projections (I) over slots (J) in dirt duct. Slide hose into slots (J) and twist hose to lock it into place. Tuck in filter bag. Replacing bag door Reposition bag door by placing tabs on bottom of door into opening (C). Press top of door to snap securely shut. Cleaning secondary filter Disconnect cleaner from electrical outlet. The secondary filter (A), located behind the grill in the bottom of bag compartment, protects the motor from dirt particles. 38765019. 3-5 3-6 Check agitator shield Because your cleaner picks up so well, we strongly recommend you check for debris accumulation under the agitator shield each time you clean the filters. B Removing debris under the shield will help maintain your cleaner's excellent pick up and suction. Remove any debris and replace shield, agitator and bottom plate (Figs. 3-13 to 3-15). Cleaning final filter The final filter assists in returning clean air to the room. To remove this filter when it becomes dirty, remove bag door and pull down top of filter. Removing and replacing filter Lift out filter (B) and hand wash it in cold water with mild detergent. Do not operate cleaner without either the secondary or final filter in place. Continued § 9 Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313101. 3-8 3-9 3-7 Install bulb - Pull old bulb straight out of socket. Excessive force is not required. Replace lens - Reposition lens and secure with the two screws. Remove lens - Disconnect cleaner from electrical outlet. Using a screwdriver, remove the two screws as shown and lift off lens. Belt replacement The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. [. . . ] Warranty service can only be obtained by presenting the appliance to one of the following Authorized Warranty Service outlets. Hoover Authorized Warranty Service Dealers (Depots) For an automated referral of authorized service outlets in the U. S. A. , phone 1-800-944-9200 OR visit The Hoover Company on-line at www. hoover. com This warranty does not cover pick up, delivery, or house calls; however, if you mail your appliance to a Hoover Factory Service Center for warranty service, transportation will be paid one way. While this warranty gives you specific legal rights, you may also have other rights which vary from state to state (or province). If further assistance is needed, or if there are questions concerning this warranty or the availability of warranty service outlets, write or phone the Consumer Response Center, The Hoover Company, 101 East Maple St. , North Canton, Ohio 44720. [. . . ]