User manual HITACHI PJ-LC5

[. . . ] Projector PJ-LC5 User's Manual - Operating Guide Thank you for purchasing this projector. WARNING Before using, read the "User's Manual - Safety Guide" and these manuals to ensure correct usage through understanding. NOTE · The information in this manual is subject to change without notice. · The manufacturer assumes no responsibility for any errors that may appear in this manual. [. . . ] · If the lamp breaks soon after the first time it is used, it is possible that there are electrical problems elsewhere besides the lamp. If this happens, contact your local dealer or a service representative. · Use the lamp of the specified type only. Type number: DT00581 (sold separately) · Handle with care: jolting or scratching could cause the lamp bulb to burst during use. · Before replacing the lamp, make sure the power switch is off and the power cable is not plugged in, then wait at least 45 minutes for the lamp to cool sufficiently. Handling the lamp while hot can cause burns, as well as damaging the lamp. At the lamp replacing, make sure that the screws are screwed in firmly. In most cases, it is possible to dispose of used bulbs in the same manner as used glass bottles, but in some cases, bulbs are sorted separately. 32 Lamp (continued) Replacing The Lamp WARNING · Please carefully read the "User's Manual - Safety Guide". CAUTION · Do not reset the lamp timer without replacing the lamp. · When you replace the lamp, please replace also the air filter. The air filter may be attached when you buy a replacement lamp for this projector. If the indicators or a message prompts you to replace the lamp, replace the lamp as soon as possible. Using the lamp for long periods of time, or past the replacement date, could cause it to burst. If the projector is mounted on the ceiling, or if the lamp has broken, do not try to clean the projector or replace the lamp yourself. 1 2 Turn off the projector, and unplug the power cord. If the projector is mounted on the ceiling, or if the lamp has broken, also ask the dealer to replace the lamp. In the case of replacement by yourself, 3 After making sure that the projector has cooled adequately, slowly flip over the projector, so that the bottom is facing up. Insert the new lamp, and tighten the 2 screws firmly to lock it in place. Lamp cover Release button 4 5 6 7 8 9 Handles Screws Slide the lamp cover into place until it locks into position. When the lamp has been replaced after the message of "THE POWER WILL TURN OFF AFTER 0hr. " is displayed, complete the following operation within 10 minutes of switching power on. (1) While the projector running, press the MENU button to open the menu. (2) Choose the "OPTION" on the menu using the button, then press the / or ENTER button. (3) Choose the "LAMP TIME" using the button, then press and hold the / of projector or the RESET button of remote control for 3 seconds. button button 33 Air Filter WARNING · Please carefully read the "User's Manual - Safety Guide". · Before replacing the air filter, make sure the power switch is off and the power cable is not plugged in. Type number: NJ08292 (sold separately) · Do not use the projector with the air filter and filter cover removed. CAUTION · Do not reset the filter timer without cleaning or replacing the air filter. [. . . ] Before using, please read the following and use the CD-ROM correctly. CAUTION · Only use the CD-ROM in a computer CD drive. Inserting the CD-ROM into an incompatible CD drive may produce a loud noise, which in turn MAY RESULT IN EAR AND SPEAKER DAMAGE!Please keep the CD neither in direct sunlight nor in a high temperature and high humidity environment. NOTE · The information in the CD-ROM is subject to change without notice. [. . . ]