User manual HITACHI HPW-630ET

[. . . ] Handheld Computer User's Guide HPW-630ET/ETR Please read this manual carefully before operating your set. Retain it for future reference. Copyright Information HITACHI is a trademark of Hitachi, Ltd. Microsoft, MS, MSN, PowerPoint, ActiveX, ActiveSync, Outlook, InkWriter, Windows, Windows NT, Visual Basic, Visual C++, and the Windows logo are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. Microsoft products are licensed to OEMs by Microsoft Licensing, Inc. , a wholly owned subsidiary of Microsoft Corporation. [. . . ] Conduct the setup at room temperature (77°F(25°C)). Note An hourglass may be displayed at the center of screen. As an hourglass is displayed over PLUS(+) mark at the center of the screen, tap the center of an hourglass by stylus pen. 2 Tap the screen gently once with the stylus pen. One press of the screen with the stylus pen is called a "tap. " 50 3 When the explanations for "Correcting the Touch Screen" is displayed, tap the screen. 4 Tap the center of the cross according to the guidance displayed on the screen. Failure to tap the screen for 30 seconds after that will invalidate the corrections of the touch screen, so that you cannot proceed. 5 Tap the LCD touch panel at any position. 6 Adjust screen brightness and contrast. Adjusting the brightness : Tap the - or + of the on the LCD touch panel. Adjusting the contrast : Tap the - or + of the on the LCD touch panel. 51 Chapter 5: Before Use 5. 1 User Configuration function You can open User Configuration function by tapping [Start], [Settings] and [Control Panel] and then double tapping [User Configuration]. <Hard Icon> You can allocate applications or documents to 1 through 5 . Note Do not allocate applications or documents stored in PC card / CF card to User icons. After powering up HPW-630ET, applications or documents allocated in User icons may not be started. You can change the display and refresh rate of the main unit LCD and the external monitor, and number of colors displayed. For more information, refer to Part 2 "Software", 1. 2. 15 "User configuration". 1 2 3 4 5 5. 2 Operating the user icons and how they react 1 2 3 4 5 : Starts the application of the user setting 1. : Starts the application of the user setting 5. Note Tapping any of the user icons 1 through 5 while powered off will not start the specified application. 52 5. 3 User A button You can allocate the application to A button. After allocating the application, if you press this button, you can execate the application. User A button Note Before allocating the application, User A button does not work. 5. 4 Notification LED The application can use the Notification LED to notify some event. Notification LED 53 Note · Prolonged continued blinking of the alarm light will drain the battery quickly. 5. 5 Infrared port When using infrared communications ports (IR ports), make the IR ports face each other as shown in the diagram below. When performing infrared communications, take care not to block HPW-630ETR from the other device. IR port IR port Use the IR ports within the range of up to 10° laterally, 10° up, and 10° down. When using the IR ports, keep the distance between the HPW-630ETR and the other device less than 50cm (20inches). IR port 10 10 to the left up 10 down 10 to the right 54 5. 6 Reset switch If HPW-630ETR crashes or a reset instruction is given when the software is installed, press the reset switch with the stylus pen and restart it. 5. 7 Full reset A full reset is conducted only when pressing the reset switch does not reboot HPW-630ETR. 1 Detach the AC adapter. See steps 2 through 3 of 4. 1. 6 "Replacing the Backup Battery". See 4. 1 "Setting the Batteries". Cautions · A full reset results in the loss of all data stored in HPW-630ETR and the installed software. · After pressing the reset switch, wait at least a second before pulling out or inserting the AC adapter. 55 5. 8 Calibration switch You can recalibrate your touch screen. 1 Press the calibration switch. The screen to recalibrate your touch screen is displayed. 2 Tap the center of the cross according to the guidance displayed on the screen. Failure to tap the screen for 30 seconds after that will invalidate the corrections of the touch screen. Press the Calibration switch again. 56 5 Tap the LCD touch panel at any position. 5. 9 Using a PC card HPW-630ETR works with commercially available PC cards (types I and II). 1 Power off HPW-630ETR. 3 Press the card eject knob in the side of HPW-630ETR, and take the PC card protector from the PC card slot. 57 3 Insert the PC card into the PC card slot with its front side facing upwards, as shown in the figure below. Front side 4 Retract the eject knob. To take out the PC card, press the card eject knob in the side of HPW-630ETR. 5 Install the PC card slot cover. Note · When using a modem card, the sound of the modem's monitor can be produced from the speaker of the HPW-630ETR. If you wish to make HPW-630ETR silent, disable the speaker output from the PC card by System tab on [User Configuration] in Control Panel. · When not using a PC card, always use HPW-630ETR with the PC card protector inserted into the slot. [. . . ] Address : 1855 Dornoch Court, San Diego, CA 92173 Telephone Number : (619) 661-0227 165 HITACHI Handheld Computer Limited Warranty Hitachi America, Ltd. Hitachi America, Ltd. ("Hitachi") warrants this product duration as stated below: 1 Year Parts 1 Year Labor Carry In Conditions of Hitachi Limited Warranty Hitachi Personal Computers are warranted to be free of defects in parts and workmanship from the time of purchase by the original owner. If this HPW-630ETR is found to be-defective, Hitachi will repair or replace defective parts at no charge for the parts to the original owner, subject to the conditions of the Limited Warranty. The labor for the repair or replacement of the defective parts will be provided by Hitachi without charge, subject to the conditions of the Limited Warranty. 1. [. . . ]