User manual HITACHI HFC-VWE2

[. . . ] CAUTION This symbol indicates information that, if ignored, could possibly result in personal injury or physical damage due to incorrect handling. NOTE · The information in this manual is subject to change without notice. · The manufacturer assumes no responsibility for any errors that may appear in this manual. · The reproduction, transfer or copy of all or any part of this document is not permitted without express written consent. [. . . ] COMPUTER IN1 ó COMPUTER IN2 (2) Use the / buttons to turn the frame lock function on/off . ON ó OFF · This item can be performed only on a signal with a vertical frequency of 49Hz to 51Hz, 59 to 61 Hz. · When ON is selected, moving pictures are displayed more smoothly. · This function may cause a certain degradation of the picture. In such a case, please select OFF. VIDEO FORMAT COMPUTER IN FRAME LOCK (continued on next page) 32 INPUT menu Item Description The resolution for the COMPUTER IN1 and COMPUTER IN2 input signals can be set on this projector. (1) In the INPUT menu select the RESOLUTION using the / buttons and press the button. (2) In the RESOLUTION menu select the resolution you wish to display using the / buttons. (3) Pressing the or ENTER button when selecting a STANDARD resolution will automatically adjust the horizontal and STANDARD vertical positions, clock phase and horizontal size. (4) To set a custom resolution use the / buttons to select the CUSTOM and the RESOLUTION_CUSTOM box will be displayed. CUSTOM Set the horizontal (HORZ) and vertical (VERT) resolutions using the /// buttons. The message "ARE YOU SURE YOU WISH TO CHANGE RESOLUTION?" appears. - The RS-232C communication control is disabled except turning the projector on and changing the STANDBY MODE setting. - The STANDBY of the MONITOR OUT (below) is invalid, and no signal is output from the MONITOR OUT port. - The AUDIO OUT STANDBY of the AUDIO SOURCE (36) is invalid, and no signal is output from the AUDIO OUT ports (15). The combination of a picture shown on screen and output from the MONITOR OUT port can be arranged in the menu. The picture coming into the port selected in the (2) is output to the MONITOR OUT port while an image from the port chosen in the (1) is on screen. (1) Choose a picture input port using / buttons. COMPUTER IN1 ó COMPUTER IN2 STANDBY COMPONENT VIDEO ó S-VIDEO ó (Y, Cb/Pb, Cr/Pr) STANDBY MODE MONITOR OUT · Select STANDBY to specify the output from the MONITOR OUT port in the standby state. This selection is available only when NORMAL is selected for the STANDBY MODE (above). COMPUTER IN1 ó OFF Choosing the COMPUTER IN2 allows the following choice. COMPUTER IN2 ó OFF Choosing other input or STANDBY allows the following choice. COMPUTER IN1 ó COMPUTER IN2 ó OFF · OFF disables the MONITOR OUT port. · Initial settings for STANDBY are the following: COMPUTER IN1 when NORMAL is selected in STANDBY MODE; and OFF when SAVING is selected in STANDBY MODE. [. . . ] If the same indication is displayed after the remedy, please contact your dealer or service company. 59 (Continued on next page) Troubleshooting Regarding the indicator lamps (continued) POWER LAMP TEMP indicator indicator indicator Description There is a possibility that the interior portion has become heated. Blinking In Red or Lighting In Red Turned off Lighting In Red Please turn the power off, and allow the projector to cool down at least 20 minutes. After the projector has sufficiently cooled down, please make confirmation of the following items, and then turn the power on again. If the same indication is displayed after the remedy, please set FAN SPEED of SERVICE item in OPTION menu to HIGH (45). It is time to clean the air filter. Lighting In Green Simultaneous blinking in Red Please immediately turn the power off, and clean or change the air filter referring to the section "Cleaning and replacing the air filter". [. . . ]