User manual HITACHI CPX5WF

[. . . ] Projector CPX1/CPX5 User's Manual (detailed) Operating Guide Thank you for purchasing this projector. WARNING WARNING CAUTION NOTE Trademark acknowledgment 1 Content About this manual. 21 EXECUTE 2 ASPECT UTO KEYSTONE KEYSTONE ICTURE MODE RIGHTNESS 3 ONTRAST OLOR INT HARPNESS 3 WHISPER IRROR ESET ILTER TIME 3 LANGUAGE 3 PICTURE menu . 23 RIGHTNESS OLOR INT ONTRAST AMMA OLOR TEMP HARPNESS Y MEMORY 3 Part names . [. . . ] Also, do not place a spread, cover, etc, over them because this could result in the inadvertent placing of heavy objects on the concealed power cord or cables. When connecting and disconnecting the power cord or cables, do it with your hand holding the plug or connector. · Do not attempt to work on the power cord. Be careful in handling the battery of the remote control. Incorrect handling of the battery could result in fire or personal injury. · Use only the battery specified in the other manual of this projector. · Make sure the plus and minus terminals are correctly aligned when loading the battery. · If you observe a leakage of the battery, wipe out the flower and then replace the battery. · Obey the local laws on disposing the battery. 4 Safety Precautions (continued) CAUTION Be careful in moving the projector. Neglect could result in an injury or damage. Before moving, disconnect the power cord and all external connections, and close the slide lens door or attach the lens cap. · For moving the projector, use the enclosed case or bag if provided. Do not put anything on top of the projector. Placing anything on the projector could result in loss of balance or falling, and cause an injury or damage. Use special caution in households where children are present. Do not attach anything other than specified things to the projector. Neglect could result in an injury or damage. Do not attach anything other than specified options (such as conversion lens) to the screw thread. Avoid a smoky, humid or dusty place. Placing the projector in a smoke, a highly humid, dusty place, oily soot or corrosive gas could result in fire or electrical shock. · Do not place the projector near a smoky, humid or dusty place (ex. · Do not use a humidifier near the projector. Take care of the air filter to normal ventilate. The air filter should be cleaned periodically. If the air filter becomes clogged by dust or the like, internal temperature rises and could cause malfunction. The projector may display the message such as "CHECK THE AIR FLOW" or turn off the projector, to prevent the internal heat level rising. · When the indicators or a message prompts you to clean the air filter, clean the air filter as soon as possible. · If the soiling will not come off the air filter, or it becomes damaged, replace the air filter. Please order the air filter specified in the other manual of this projector to your dealer. The air filter may be attached when you buy a replacement lamp for this projector. · Do not turn on the projector without air filter. Avoid a high temperature environment. The heat could have adverse influence on the cabinet of the projector and other parts. Do not place the projector, the remote control and other parts in direct sunlight or near a hot object such as heater, etc. Avoid Magnetism. Manufacture strongly recommends to avoid any magnetic contact that is not shielded or protected on or near the projector itself. Magnetic Security Devices, or other projector accessory that contains magnetic material that has not been provided by the manufacture etc. ) Magnetic objects may cause interruption of the projector's internal mechanical performance which may interfere with cooling fans speed or stopping, and may cause the projector to completely shut down. [. . . ] · Using the lamp for long periods of time, could cause it dark, not to light up or to burst. When the pictures appear dark, or when the color tone is poor, please replace the lamp as soon as possible. Do not use old (used) lamps; this is a cause of breakage. Disconnect the plug from the power outlet 8 Regulatory Notices FCC Statement Warning WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]