User manual HITACHI CP-X3010

[. . . ] Projector CP-X2010/CP-X2510/CP-X3010 User's Manual (detailed) Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read all manuals for this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. WARNING This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling. [. . . ] The horizontal and vertical positions, clock phase and horizontal size will be automatically adjusted. After the INPUT_INFORMATION dialog has displayed for about 10 seconds the screen will return to the RESOLUTION menu displaying the changed resolution. (6) To revert back to the previous resolution without saving changes place the cursor on the left-most digit and press the button. The screen will then return to the RESOLUTION menu displaying the previous resolution. · For some pictures, this function may not work well. RESOLUTION 33 SETUP menu SETUP menu From the SETUP menu, items shown in the table below can be performed. Select an item using the / cursor buttons, and press the cursor button or ENTER button to execute the item. Then perform it according to the following table. Item Description Selecting this item performs the Automatic keystone distortion correction. Projector automatically corrects vertical keystone distortion due to the (forward/backward) setup angle by itself. When the slant of the projector is changed, execute this function again. · The adjustable range of this function will vary among inputs. · When V:INVERT or H&V:INVERT is selected to the MIRROR item AUTO KEYSTONE in the SETUP menu, if the projector screen is inclined or angled downward, this function may not work correctly. EXECUTE · When the zoom adjustment is set to the TELE (telephoto focus), this function may be excessive. This function should be used when the zoom adjustment is set to the full WIDE (wide-angle focus) whenever possible. · When the projector is placed on the level (about ±3°), this function may not work. · When the projector is inclined to near ±30 degree or over, this function may not work well. · This function will be unavailable when the Transition Detector is on (50). Shrink the bottom of the image Shrink the top of the image · The adjustable range of this function will vary among inputs. · When the zoom adjustment is set to the TELE (telephoto focus), this function may be excessive. This function should be used when the zoom adjustment is set to the full WIDE (wide-angle focus) whenever possible. · This function will be unavailable when the Transition Detector is on (50). NORMAL ECO · When the ECO is selected, acoustic noise and screen brightness are reduced. KEYSTONE ECO MODE (continued on next page) 34 SETUP menu Item Description Using the / buttons switches the mode for mirror status. MIRROR NORMAL H:INVERT V:INVERT H&V:INVERT If the Transition Detector is on and MIRROR status is changed, TRANSITION DETECTOR ON alarm (50) will be displayed when projector is restarted after the AC power is turned off. Using / buttons switches the standby mode setting between NORMAL and SAVING. [. . . ] Please disconnect the power plug from the power outlet, and allow the projector to cool down at least 10 minutes, then turn the power on again. 11, 14 Either there is no lamp and/or lamp cover, or either of these has not been properly fixed. Please turn the power off and disconnect the power plug from the power outlet, and allow the projector to cool down at least 45 minutes. After the projector has sufficiently cooled down, please make confirmation of the attachment state of the lamp and lamp cover, and then turn the power on again. 53, 54 The signal cables are not correctly connected. Correctly connect the connection cables. 9 ­ 15, 16 Signal source does not correctly work. Correctly set up the signal source device by referring to the manual of the source device. [. . . ]