User manual HITACHI CP-WX410

[. . . ] Projector CP-WX410 User's Manual (detailed) Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read all manuals for this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. WARNING This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling. [. . . ] COMPONENT ó SCART RGB When the SCART RGB is selected, COMPONENT (Y, Cb/Pb, Cr/ Pr) and VIDEO ports will function as a SCART RGB port. For your reference, see the TECHNICAL part. PROGRESSIVE COMPONENT (continued on next page) 31 INPUT menu INPUT menu (continued) Item Description The video format for S-VIDEO port and VIDEO port can be set. AUTO ó NTSC ó PAL ó SECAM N-PAL ó M-PAL ó NTSC4. 43 · This item is performed only for a video signal from VIDEO port or S-VIDEO port. an irregular picture, lack of color), please select the mode according to the input signal. AUTO ó NOMAL ó ENHANCED HDMI Feature Selecting the optimum mode automatically Suitable for DVD singals(16-235) Suitable for VGA signals(0-255) VIDEO FORMAT AUTO NORMAL ENHANCED ·If the contrast of the screen image is too strong or too weak, try finding a more suitable mode Set the frame lock function on/off for each port. QUIT ó COMPUTER(IN)1 ó COMPUTER(IN)2 ó HDMI (2) Using the / buttons to turns the frame lock function on/off. TURN ON ó TURN OFF · This item can be performed only on a signal with a vertical frequency of 50 to 60 Hz. · When the TURN ON is selected, the moving pictures are displayed more smoothly. · This function may cause a certain degradation of the picture. The computer input signal type for COMPUTER IN1 and IN2 ports can be set. COMPUTER (IN)1 ó COMPUTER (IN)2 (2) Use the / buttons to select the computer input signal type. AUTO ó SYNC ON G OFF (continued on next page) FRAME LOCK COMPUTER IN (continued on next page) 32 INPUT menu INPUT menu (continued) Item Description Selecting the AUTO mode allows you to input a sync on G signal or component signal from the port. · In the AUTO mode, the picture may be distorted with certain input signals. In such a case, remove the signal connector so that no signal is received and select the SYNC ON G OFF, and then reconnect the signal. The resolution for the COMPUTER IN1 and IN2 input signals can be set on this projector. (1) In the INPUT menu, select the RESOLUTION using the / buttons and press the button. (2) In the RESOLUTION menu, select the resolution you wish to display using the / buttons. (3) STANDARD Pressing the or ENTER button when STANDARD selecting a STANDARD resolution will automatically adjust the horizontal and vertical positions, clock phase and horizontal size and automatically select an aspect ratio. (3) CUSTOM (3)-1 To set a custom resolution, use the CUSTOM / buttons to select the CUSTOM and the CUSTOM RESOLUTION box will be displayed. Set the horizontal (HORZ) and vertical (VERT) resolutions using the /// buttons. It is not guaranteed to work this function properly on any resolutions. (3)-2 To save the setting place the cursor on the right-most digit and press the button. [. . . ] Header + Command data (`01H' + `00H' + type (2 bytes) + setting code (2 bytes)) (2) The projector changes the setting based on the above setting code. Using the projector default settings (Reset Command) (1) The PC sends the following default setting code to the projector. Header + Command data (`06H' + `00H' + type (2 bytes) + `00H' + `00H') (2) The projector changes the specified setting to the default value. Increasing the projector setting value (Increment command) (1) The PC sends the following increment code to the projector. [. . . ]