User manual HITACHI CPS235

[. . . ] Projector CP-S235 User's Manual - Operating Guide Thank you for purchasing this projector. WARNING Before using, read the "User's Manual - Safety Guide" and these manuals to ensure correct usage through understanding. NOTE · The information in this manual is subject to change without notice. · The manufacturer assumes no responsibility for any errors that may appear in this manual. [. . . ] In such a case, please select the TURN OFF, even though the screen image may lose the crisp. · This function may cause a certain degradation of the picture. Display the Information: Pressing the or the ENTER button performs this function. · Use this function when you want the information about the current input (ex. the resolution and the vertical frequency at a RGB input, the signal type of a video input) and setting states of the COMPONENT, the VIDEO and the FLAME LOCK. Select the S2-ASPECT Mode: TURN ON TURN OFF · This function performs only at a S-VIDEO input. · When the TURN ON is selected, an S2-Video signal can be identified and the optimum aspect ratio is automatically selected. · When the ASPECT button of the remote control is used or the ASPECT item of the MAIN menu is operated, the S2-ASPECT mode will be switched to the TURN OFF automatically. Reset the INPUT Menu Items: Selecting the EXECUTE performs this function. EXECUTE CANCEL · The items of the INPUT menu are collectively returned to the initial setting. Note that the INFORMATION item is not reset. VIDEO NR PROGRESSIVE INFORMATION S2-ASPECT RESET 28 Multifunctional Settings (continued) AUTO Menu With the AUTO menu, the items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below. Item Description Automatically Adjust the Picture: Pressing the or the ENTER button performs this function. At a RGB input: · V POSITION, H POSITION, H PHASE and HSIZE are automatically adjusted. At a VIDEO input or S-VIDEO input: · This function performs only when the AUTO is selected under the VIDEO item of the INPUT menu. For a COMPONENT VIDEO input, although this function is ineffective, the signal type is identified automatically even if the AUTO is not selected. · This function automatically selects the optimum mode for the input signal. However, it may not work well at a PAL60 signal and some other signals. irregular picture, color lack), please use the function of VIDEO of the INPUT menu. · The operation of this function requires approximately 10 seconds. 0 minute =DISABLE) · This function performs only when the time is set to 1 to 99. · When the set time passes without a valid signal (there is no signal, or the signal is out of specifications), the projector lamp automatically goes off, and the POWER indicator begins blinking. Please refer to the section "Turning OFF The Power" of "Power ON/OFF" about the turning off. [. . . ] After the unit has sufficiently cooled down, Blinking in please make confirmation of the following item, and then red resent the power to ON. · Is there no foreign matter caught in the cooling fan? There is a possibility that the interior portion has become heated. After the unit has sufficiently cooled down, please make Lighting or Lighting in confirmation of the following item, and then resent the power blinking in Turned off to ON. · Does the peripheral temperature exceed 35°C? Lighting in green Alternative blinking in the red There is a possibility that the interior portion has become overcooled. [. . . ]