User manual HITACHI CP-X250WF

[. . . ] Projector CP-S240/CP-X250 User's Manual ­ Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read the "User's Manual Safety Guide" and related manuals to ensure the proper use of this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. WARNING This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling. [. . . ] Right Left · This item can be selected only for an RGB signal or a component video signal. Note that this does not work with the input signal of 525i(480i)/625i(576i)/SCART RGB from the component video port. MENU[RGB] PICTURE IMAGE INPUT SETUP SCREEN OPTION EASYMENU :SELECT ASPECT4:3 OVERSCAN5 VPOSITION25 HPOSITION142 HPHASE16 HSIZE1344 AUTOADJUSTEXECUTE OVER SCAN V POSITION H POSITION H PHASE 30 Multifunctional settings IMAGE Menu (continued) Item Description Using the buttons / adjusts the horizontal size. Large Small · This item can be selected only for an RGB signal. · When this adjustment is excessive, the picture may not be displayed correctly. In such a case, please reset the adjustment by pressing the RESET button on the remote control during this operation. For an RGB signal The vertical position, the horizontal position, the clock phase and the horizontal size will be automatically adjusted. Make sure that the application window is set to its maximum size prior to attempting to use this feature. For a video signal or s-video signal The video format best suited for the respective input signal will be selected automatically. This function is available only when the AUTO mode is selected to the VIDEO FORMAT item in the INPUT menu. For a component video signal, the signal type is identified automatically independently of this function. For a video signal, s-video signal or component video signal The vertical position and horizontal position will be automatically adjusted. For a component video signal The aspect ratio will be automatically selected. · The automatic adjustment operation requires approximately 10 seconds. Also please note that it may not function correctly with some input. H SIZE AUTO ADJUST EXECUTE 31 Multifunctional settings INPUT Menu With the INPUT menu, the items shown in the table below can be performed. Select an item using the cursor buttons / on the projector or remote control, and press the cursor button on the projector or remote control, or the ENTER button on the remote control to execute the item. Then perform it referring to the following table. Item Description Using the buttons / switches the mode for color space. AUTO RGB SMPTE240 REC709 REC601 COLOR SPACE · This item can be selected only for an RGB signal or a component video signal (except signals of 525i(480i)/625i(576i)/SCART RGB from the component video port). In such a case, it might be good to select a suitable mode except AUTO. COMPONENT SCART RGB When the SCART RGB is selected, the COMPONENT VIDEO port function as a port for a SCART RGB signal input. A SCART adapter and SCART cable realize a SCART RGB input to the projector. AUTO NTSC PAL SECAM N-PAL M-PAL NTSC4. 43 · This item is performed only for a video signal from the VIDEO port or the S-VIDEO port. For a component video signal, the signal type is identified automatically independently of this function. [. . . ] (3) The projector returns the response code `06H' to the computer. Using the projector default settings (Reset Command) (1) The computer sends the default setting code Header + Command data (`06H'+ `00H' + type (2 bytes) +`00H'+`00H') to the projector. (3) The projector returns the response code `06H' to the computer. Increasing the projector setting value (Increment command) (1) The computer sends the increment code Header + Command data (`04H'+ `00H'+ type (2 bytes) +`00H'+`00H') to the projector. [. . . ]