User manual HITACHI CP-A301NM

[. . . ] WARNING This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling. CAUTION This symbol indicates information that, if ignored, could possibly result in personal injury or physical damage due to incorrect handling. NOTE · The information in this manual is subject to change without notice. · The manufacturer assumes no responsibility for any errors that may appear in this manual. [. . . ] CAUTION Please take right care of the projector according to the following. Incorrect care could cause not only an injury but adverse inuence such as discoloration, peeling paint, etc. Do not use cleaners or chemicals other than those specied in this manual. NOTICE Do not directly touch the lens surface with hands. 95 Troubleshooting Troubleshooting If an abnormal operation should occur, stop using the projector immediately. WARNING Never use the projector if abnormal operations such as smoke, Troubleshooting strange odor, excessive sound, damaged casing or elements or cables, penetration of liquids or foreign matter, etc. In such cases, immediately disconnect the power plug from the power outlet. After making sure that the smoke or odor has stopped, contact to your dealer or service company. Otherwise if a problem occurs with the projector, the following checks and measures are recommended before requesting repair. If this does not resolve the problem, please contact your dealer or service company. They will tell you what warranty condition is applied. Related messages When some message appears, check and cope with it according to the following table. Although these messages will be automatically disappeared around several minutes, it will be reappeared every time the power is turned on. Message Description There is no input signal. Please conrm the signal input connection, and the status of the signal source. After the projector has sufciently cooled down, please make conrmation of the following items, and then turn the power on again. · Is the projector used at an altitude of about 1600 m or higher?If the projector is used at an altitude of about 1600 m or higher, set FAN SPEED of the SERVICE item in the OPTION menu to HIGH ( 58). The lens door is not opened properly. Lighting In Red Turned off Turned off One of the followings has been happened. · The lens door is not opened properly, when the projector is turned on. · The lens door position is shifted, while the projector is working. Restart the projector, after conrming that there is nothing that the lens door hits while opening or closing. Please immediately turn the power off, and clean or change the air lter referring to the section "Cleaning and replacing the air lter". After cleaning or changing the air lter, please be sure to reset the lter timer. After the remedy, reset the power to ON. Lighting In Green Simultaneous blinking in Red Lighting In Green Blinking In Green for approx. 3 seconds. Alternative blinking in Red There is a possibility that the interior portion has become overcooled. Please use the unit within the usage temperature parameters (5°C to 35°C). After the treatment, reset the power to ON. Turned off Turned off At least 1 Power ON schedule is saved to the projector. [. . . ] Please keep the CD neither in direct sunlight nor in a high temperature and high humidity environment. NOTE · The information in the CD-ROM is subject to change without notice. · No responsibility is taken for any obstacle and defect to hardware and software of your PC as a result of the use of the CD-ROM. · All or Any part of the information in the CD-ROM must not be copied, reproduced or republished without notice to our company. 20 Specifications Item Product name Liquid Crystal Panel Lamp Speaker Power supply Power consumption Temperature range Size Weight (mass) Liquid crystal projector 210W UHP 10W AC 100-120V/3. 1A, AC 220-240V/1. 6A AC 100-120V:310 W, AC 220-240V:300W 5 ~ 35°C (Operating) 345 (W) x 85 (H) x 303 (D) mm * Not including protruding parts. [. . . ]