User manual HITACHI CML158XW

[. . . ] COLOUR LCD MONITOR CML158XW USER MANUAL MANUEL D'UTILISATION BEDIENUNGSANLEITUNG MANUAL DE USUARIO MANUALE DI ISTRUZIONI READ THE INSTRUCTIONS INSIDE CAREFULLY. KEEP THIS USER MANUAL FOR FUTURE REFERENCE. For future reference, record the serial number of your colour monitor. SERIAL No. The serial number is located on the rear of the monitor. This monitor is ENERGY STAR® compliant when used with a computer equipped with VESA DPMS. The ENERGY STAR® emblem does not represent EPA endorsement of any product or service. [. . . ] This will change the flow of air through the air vents and cause the internal temperature to rise resulting in fire or malfunction. Placing Objects in Device DO NOT put paper clips, pins, metallic objects or combustible items in the ventilation holes. Using the device in this condition may result in electrical shock or fire. Removing the Case Cover DO NOT remove the case cover. There are many high voltage parts inside and are very dangerous. Placing Objects on the Device DO NOT put flower vases, planters, vessels containing water, pins and paper clips or other metal items on the device. If anything should fall in, using the product in this condition may result in electrical shock. 6 Handling of the power cord Use the power cord supplied with the product and be careful of the following during use. If handled improperly, the cord may be damaged resulting in electrical shock or fire. -DO NOT pull -DO NOT apply pressure -DO NOT fold -DO NOT wrap -DO NOT use next to heating device Plugging and Unplugging - When plugging or unplugging the power cord in the socket, make sure to hold the plug. Pulling on the power cord may cause a partial breakage resulting in fire. - When taking a holiday or vacation and leaving the device unused for prolonged periods, unplug the power cord. - When unplugging or plugging in the power cord, insure that your hands are dry. Handling with wet hands may result in electrical shock. Poor Electrical Contact in Electric Plug, etc. The following must be done to prevent bad contact in the electrical plug that may result in fire. Check to see if there is no dust accumulated on the plug before plugging in. DO NOT use a socket that is loose or wobbles. Impact from Dropping To not drop, bang or subject to physical shock. Using after such incidents may result in electrical shock or fire. Power Usage The usable voltage is 100-120V / 200-240VAC. This may result in electrical shock or fire. 7 Multi-Tap Usage TO not attach multiple extension plugs into one outlet. This may result in fire and overloading lines will activate the circuit breakers causing data loss or damage to the product. Usage in Humid or Dusty Areas DO NOT use or store in areas that are humid, dusty or have abundant moisture such as a bathroom. This may cause fire or electrical shock. Moving to Areas of Different Temperature Moving the device to areas that are very different in temperature may cause condensation on the outside and internally. Using the device in this condition may result in fire or electrical shock. Leave the device at the location for a few hours before using. Aluminium Electrolysis Condenser The electrolyte condenser used in the AC adapter has a limited life. If used past the life span (approximately 5 years), replace the AC adapter. Leakage or drying up of the electrolyte liquid may result in fire, electrical shock. This may also cause the device itself to malfunction. Damage to the Display Unit Liquid may leak out of the display when damaged. If you should touch the liquid, wash your hands thoroughly with water. [. . . ] (typical) Vertical: -55° ~ +45° Horizontal: -65° ~ +65° Pixel fault class: Class II 16. 7M with FRC or Dithering Analog RGB 0. 7Vp-p 75 Ohm ± 2% Positive 0 - 0. 7 ± 0. 05 Vp Horizontal Frequency: 24 ~ 61KHz Vertical Frequency: 49 ~ 75Hz 500mVrms 1W+1W On/Off switch with LED indicator Digital Digital Digital Digital Digital Digital Use EEPROM to save settings in memory 20 characters x 9 rows 17 ISO 13406-2 Display Colours Video Input Signal Input Impedance Polarity Amplitude Multi-mode Supported Audio Input Output Control Power OSD Brightness Contrast Horizontal Position Vertical Position Phase Clock Display Mode Setup OSD Format Power Management Mode On Standby Suspend Off DC Power Off Disconnected Power Consumption* 30W maximum 3W maximum 3W maximum 3W maximum 3W maximum 3W maximum AC Input 240 VAC 240 VAC 240 VAC 240 VAC 240 VAC 240 VAC LED Color Green Yellow Yellow Yellow Dark Yellow: Standby, Suspend, Off Dark: DC Power off * Meeting VESA DPMS requirements measured from AC Input. Sync Input Signal Polarity Separate TTL compatible horizontal and vertical synchronisation Positive and negative Supports VESA DDC1 and DDC2B functions AC socket 1. 5M with 15-pin D-sub connector 1. 5M with Stereo Jack Plug & Play External Connection Power Input (AC input) Video Cable Audio Cable Environment Operating Condition: Temperature Relative Humidity Storage Condition: Temperature Relative Humidity 5°C to 40°C/41°F to 104°F 20% to 80% -20°C to 60° C/-4°F to140° F 5% to 85% Single phase, 100 ~ 240VAC, 50 / 60 Hz 1. 2 A maximum 352 (W) x 343 (H) x 176 (D) mm 2. 9 ± 0. 3Kg 4. 4 ± 0. 3Kg Power Supply Input Voltage Input Current Size and Weight Dimensions Net Weight Gross Weight 18 Pin Assignment 6 Signal PIN 1 Description Red Green Blue Digital GND Digital GND Red Rtn Green Rtn Blue Rtn PIN 9 10 11 12 13 14 15 Signal Description +5V Cable Detection Digital GND SDA H. SCL 1 11 2 3 4 5 15 5 6 7 10 8 Standard Timing Table If the selected timing is NOT included in table below, this LCD monitor will use the most suitable available timing. Resolution 640 x 350 640 x 400 640 x 400 640 x 480 640 x 480 640 x 480 720 x 400 800 x 600 800 x 600 800 x 600 800 x 600 832 x 624 1024x 768 1024x 768 1024x 768 1024x 768 H. (KHz) 31. 469 24. 830 31. 469 31. 469 37. 861 37. 500 31. 469 35. 156 37. 879 48. 077 46. 875 49. 725 48. 363 53. 964 56. 476 60. 023 V. (Hz) 70. 087 56. 420 70. 087 59. 940 72. 809 75. 000 70. 087 56. 250 60. 317 72. 188 75. 000 74. 55 60. 004 66. 132 70. 069 75. 029 Pixel Freq. [. . . ]