User manual HITACHI CJ110MVA

[. . . ] Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. [. . . ] Extension cord When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. A) Wear a dust mask b) Use external dust collection equipment When using the external dust collection equipment, connect the adapter with the hose from external dust collection equipment. 1-III) CAUTION: Be sure to switch power OFF and disconnect the plug from the receptacle when changing blades. Adjusting the blade operating speed This Jig Saw is equipped with the electric control circuit which enables stepless speed control. When the dial is set to "1", the jig saw operates at the minimum speed (850min­1). When the dial set to "5", the jig saw Cutting various lumber and pocket cutting Cutting mild steel plate, aluminum plate, and copper plate Cutting synthetic resins, such as phenol resin and vinyl chloride Cutting thin and soft construction materials Cutting stainless steel plate (with No. Power source Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate. If the plug is connected to a receptacle while the power 7 Adjust the speed according to the material to be cut and working efficiency. CAUTION: At low speed (dial setting: 1 or 2) do not cut a wood with a thickness of more than 10 mm or metal with a thickness of more than 1 mm. Adjusting the orbital operation (1) This Jig Saw employs orbital operation which moves the blade back and forth, as well as up and down. The orbital operation can be selected in 4 steps from "0" to "III". Cutting stainless steel plates This Jig Saw can cut stainless steel plates by using No. Carefully read "Concerning cutting of stainless steel plates" for proper operation. Splinter guard Using the splinter guard when cutting wood materials will reduce splintering of cut surfaces. Insert the splinter guard in the space on the base, and push it completely. Chip cover Chip cover prevents chips from flying off and improves the efficiency of dust collector. Insert the chip cover between the base and lever, and push with a slight pressure until it catches in place. 7) When removing chip cover, hold both sides of knob and slightly open until it can be removed from the Jig Saw. 8) NOTE: There is a possibility that chip cover is frosted when cutting the metal. Sub base Using the sub base (made from steel) will reduce abrasion of aluminium base especially in cutting metals. Using the sub base (made from resin) will reduce scratching of cut surface. CAUTION: Do not look in the light or see the source of light directly. [. . . ] Used D: Remarks CAUTION Repair, modification and inspection of Hitachi Power Tools must be carried out by a Hitachi Authorized Service Center. This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service Center when requesting repair or other maintenance. In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country must be observed. MODIFICATION Hitachi Power Tools are constantly being improved and modified to incorporate the latest technological advancements. [. . . ]