User manual HITACHI C 6MFA

[. . . ] When not in use, tools should be stored in dry and high or locked-up place-out of reach of children. It will do the job better and safer at the rate for which it was intended. Don't force small tool or attachment to do the job of a heavy-duty tool. Don't use tool for purpose not intended --for example --don't use circular saw for cutting tree limbs or logs. [. . . ] Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and Do not use saw blades which are deformed or cracked. Do not use saw blades which do not comply with the characteristics specified in these instructions. Never use the circular saw which its safely cover fixed in the open position. ensure that the retraction mechanism of the guard system operates correctly. The saw blades body must be thinner than the riving knife and the width of cut, or kerf (with teeth set) must be greater than the thickness of the riving knife. Never operate the circular saw with the saw blade turned upward or to the side. The riving knife should always be used except when plunging in the middle of the work piece. The saw blades should be from 305 mm to 335 mm external diameter ranges. * Be sure to check the nameplate on product as it is subject to change by areas. When the base and saw blade are at a perpendicular angle, use the link scale to adjust the cutting depth. Measure the distance that the saw blade extends to adjust the cutting depth to the correct distance because the scale marks are only indicated for reference. Always take care in preventing the power cord from coming near the revolving saw blade. Since an excessively worn carbon brushes can result in motor trouble, replace the carbon brushes with new ones having the same carbon brush No. Shown in the figure when they become worn to or near the "wear limit". In addition, always keep carbon brushes clean and ensure that they slide freely within the brush holders. Maintenance of the motor The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does not become damaged and/or wet with oil or water. NOTE Due to HITACHI's continuing program of research and development, the specifications herein are subject to change without prior notice. IMPORTANT Correct connection of the plug The wires of the mains lead are coloured in accordance with the following code: Blue: -Neutral Brown: -Live As the colours of the wires in the mains lead of this tool may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire coloured blue must be connected to the terminal marked with the letter N or coloured black. The wire coloured brown must be connected to the terminal marked with the letter L or coloured red. nOTE This requirement is provided according to BRITISH STANDARD 2769: 1984. Therefore, the letter code and colour code may not be applicable to other markets except the United Kingdom. [. . . ] 8 (a)), mount the saw blade to washer (A) whose size is identical with the saw blade inner diameter, and the concave side of washer (B) faces the saw blade. 8 (b)), mount the adapter ring to washer (A) whose size is identical with the adapter ring inner diameter and mount the saw blade on the adapter ring, and the concave side of washer (B)) faces the saw blade. (3) To check proper rotation direction of the saw blade, the arrow direction on the saw blade must coincide with the arrow direction embossed on the saw cover. (4) Using the fingers, tighten the hexagon head bolt retaining the saw blade as much as possible. [. . . ]