User manual HITACHI 22LD4200

[. . . ] Instructions for use GB 22LD4200 Contents Remote Control Buttons . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation of device on the wall (Optional) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Inserting batteries in the remote control handset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (Automatic Programming System) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If a signal is found or reaches to end of the band after searching, press or buttons to continue search process. Selecting Fine Tuning You can use the Fine Tuning process for fine adjustment (after coarse adjustment), if you are not happy about the image on the screen. Use or button on Fine Tuning item, until getting the best image on the screen. Normally the Fine Tuning cursor is placed next to the left side on the slider and this is indicated with one arrow. Setting VCR ( Video Cassette Recorder ) Mode This item can be seen in TV, AV-1, AV-2, AV-3, S-VIDEO modes. If you want to watch a VCR source from one of these modes, then it will be better to set VCR mode on. For this, while the cursor is on this item press the or buttons to set it On. If you want to watch a DVD , then you must set this item off; because DVD is not a source like a VCR and to see the picture better, you must set the VCR mode Off. To Store Settings Press OK button on the remote control to store the settings directly. or, Press , or OK button on Store option to store Install menu settings. using or button. Then enter the Programme menu, press / or OK button. 0HQX Moving cursor to four direction you can reach 20 programmes in the same page. By scrolling the pages up or down by pressing the navigation buttons you can select all the programmes in TV mode (except the AV mode). It is also possible to select programme by using digit or doubledigit button. When using double-digit button in order to select a programme, the Programme Number in TV Status OSD is displayed in "P --" form, and by pressing digit buttons they are displayed in it. After autostore process the Programme Names are set to: Channel search "C-01" or "S-01" (band and channel number) or name of the tuned channel if defined. 3URJUDP 3 Programme Menu To enter Programme menu directly, press the " " button in TV mode, or Press "M" button, now you are in main menu. - 17 - 1DPH 'HOHWH , QVHUW $XWRVWRUH At the bottom of the menu there is a programme sort functions section. Insert section is for inserting programmes into another programme spaces. Name: To change the name of a programme, select the programme and then press the RED (Name) button. To change that letter or button can be used, and to select the other letters, or button can be used. If the cursor is at the last letter of the Programme Name, pressing button moves the cursor at the beginning. On the contrary, if the cursor is at the beginning of the Programme Name, pressing button moves the cursor at the end. After activating the name process the Insert, Delete and Autostore processes will be inactive and "Cancel" option will be valid. [. . . ] Check that the Brightness and/or the Contrast adjustments of the Display have not been turned down to minimum levels. Colours of image on screen are abnormal For TV : Have you selected the correct TV system?Is your TV set or house aerial located too close to the loudspeakers, non-earthed audio equipment or neon lights, etc. Mountains or high buildings can cause double pictures or ghost images. Sometimes you can improve the picture quality by changing the direction of the aerial. [. . . ]