User manual GRAUPNER MULTILADER 3

[. . . ] It can charge up to three batteries simultaneously, and is designed for direct connection to a 110~240V AC/ 50/60 Hz mains power socket. The unit is comprehensively protected against overload and short-circuit, and is maintenance-free in operation. Before using the charger for the first time Please read right through these instructions before you use the charger for the first time. [. . . ] - Batteries installed in a device, or which are electrically connected to other components when on charge. Liability exclusion: we at GRAUPNER have no control over the way you install, use and maintain this battery charger, nor whether you keep to the operating instructions. For this reason the company accepts no liability whatever for injury, damage to property or financial loss which result from the incorrect or improper use of this charger, or are connected with it in any way. note: exhausted and defective batteries must not be disposed of in the normal household waste. The charger is suitable for charging the following types of battery: NiMH or NiCd packs with a capacity of 0, 6 - 5Ah. They are mechanically robust, can be used in any attitude and are not damaged by vibration. You can usually tell the number of cells and capacity of a pack by its designation: the number before the slash (/) or (-) indicates the number of cells, and allows you to calculate the pack's voltage (single cell = 1. Charging batteries During the charging process a particular quantity of energy is fed into the battery, which can be calculated by multiplying charge current by charge time. The maximum permissible charge current varies according to the type of cells in the pack; the figure can be found in the data sheets supplied by the battery manufacturer. The standard (slow) charge current should only be exceeded with batteries which are marked expressly as rapid-charge types. All three output include a delta-peak cut-off detection and does finish charging. 2) below shows the polarity of the three charge leads attached to the charger and it correspondent LED. OPERATION: 1 Firstly, ensure that the battery connectors and the charge lead connectors is correct as shown on Fig. 2 Connect the discharged battery pack to the charger using the matching charge lead. 3 Connect the charger to a easily accessible AC mains socket near to the charger. the correspondent LED should now light up (RED) to indicate that the charging is in progress. Note: The charger can charge two or three packs simultaneously and charging can be started at any time. When one (two) battery pack is being charging, you can charge two (one) more packs at any time. [. . . ] Environnemental Protection Notes When this product comes to the end of its useful life, you must not dispose of it in the ordinary domestic waste. The correct method of disposal is to take it to your local collection point for recycling electrical and electronic equipment. The symbol shown here, which may be found on the product itself, in the operating instructions or on the packaging, indicates that this is the case. [. . . ]