User manual GRAUPNER LIPO DISCHARGE PROTECTION 2-10

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. 6 Safety Notes · The case slots serve to cool the charger, and must not be covered or enclosed; set up the charger with space round it, so that cooling air can circulate unhindered. The charger is designed to be powered by a 12 V car battery (11 - 16 V DC) or with the power supply to a mains socket (100 ~ 240 V AC). [. . . ] The car's engine must be stopped all the time the LiPo BALANCER CHARGER 2 - 3S is connected to the car's battery. Do not recharge the car battery at any time when the LiPo BALANCER CHARGER 2 - 3S is connected to it. The charge output sockets and connecting leads must not be modified, and must not be inter-connected in any way. There is a danger of short-circuit between the charge outputs and the vehicle's bodywork when the charger is connected to the car battery. The charge leads and connecting leads must not be coiled up when the charger is in use. Avoid short-circuiting the charge output or the model battery with the car bodywork. For this reason the charger must never be placed directly on the vehicle's bodywork. Never leave the charger running or connected to the car battery unsupervised. Only one battery may be connected to the charger for charging at any one time. The only types of battery which may safely be connected to the charger are: Lithium-Polymer packs consisting of two to three cells. To avoid short-circuits between the crocodile plugs fitted to the charger lead, please always connect the charger lead to the charger first, and only then to the battery to be charged. The green and red LED of the charger are lighting, 1 second later they will be off. now you can connect the battery 2S or 3S (2 or 3 cells) balancer connector Graupner-EH to the charger. Make sure for the right polarity of your battery balancer connector Graupner-EH. From right handed to left side: Pin 1 (GND): Ground = battery -, Pin 2 (1): + cell 1 Pin 3 (2): + cell 2 Pin 4 (3): + cell 3 Contact 2 or 3 cells to the charger output correctly, make sure, positive is on the left side and negative on the right side. Move charger away after charging, do not contact Charger with battery after charged full. Finished charging, take off the charger from AC · Do not put something on it during charging. Working Temperature is from 0 to 40°C, the better If the single cell voltage difference of 2S or 3S is Bigger, the charge time may be longer. AC power supply should be only the original one · If the DC power is less then 10V, the charger can · Before using, customers must read this manual. Any accident lead by incorrect using method (other then specified), manufacturer, distributor, retailers will not be responsible. Using the charger for the first time Using the charger for the first time charge mode The batteries will be charge with CC/CV charge method and the cells will be balanced , too. Error mode Red LED flash: Connect battery with wrong polarity or short circuit. [. . . ] Environmental Protection Notes Whenever you see this symbol on a product, in the user instructions or the packaging, it means that you must not dispose of that item, or the electronic components in it, in the ordinary domestic waste when it comes to the end of its useful life. The correct method of disposal is to take it to your local collection point for recycling electrical and electronic equipment. Individual markings indicate which materials can be recycled and re-used. You can make an important contribution to the protection of our shared environment by re-using the product, recycling the basic materials or recycling redundant equipment in other ways. [. . . ]