User manual GIGABYTE 8I845GE-RZ

[. . . ] 8I845GE-RZ / 8I845GE-RZ-C Intel® Pentium® 4 Processor Motherboard User's Manual Rev. 1001 12ME-I845GERZ-1001 Copyright © 2004 GIGABYTE TECHNOLOGY CO. , LTD Copyright by GIGA-BYTE TECHNOLOGY CO. , LTD. No part of this manual may be reproduced or transmitted in any from without the expressed, written permission of GBT. Trademarks Third-party brands and names are the property of their respective owners. Notice Please do not remove any labels on motherboard, this may void the warranty of this motherboard. Due to rapid change in technology, some of the specifications might be out of date before publication of this booklet. [. . . ] is 13:00:00. IDE Primary Master, Slave / IDE Secondary Master, Slave IDE HDD Auto-Detection Press "Enter" to select this option for automatic device detection. IDE Prim ary/Secondary Master(Slave) setup You can use one of the three methods below: Auto Allows BIOS to autom atically detect IDE devices during POST. (Default value) None Select this if no IDE devices are used and the system will skip the autom atic detection step and allow for faster system start up. Manual User can manually input the correct settings Access Mode Use this to set the access mode for the hard drive. The four options are: CHS/LBA/Large/Auto (Default:Auto) Hard drive information should be labeled on the outside drive casing. Cylinder Number of cylinders Head Number of heads Precomp Write precomp Landing Zone Landing zone Sector Number of sectors - 23 - BIOS Setup English Drive A / Drive B The category identifies the types of floppy disk (drive A and drive B) installed in the computer. None No floppy disk is installed 360K, 5. 25" 5. 25 inch PC-type standard drive; 360K byte capacity. 1. 2M, 5. 25" 5. 25 inch AT-type high-density drive; 1. 2M byte capacity (3. 5 inch when 3 M ode is Enabled). 720K, 3. 5" 3. 5 inch double-sided drive; 720K byte capacity 1. 44M, 3. 5" 3. 5 inch double-sided drive; 1. 44M byte capacity. 2. 88M, 3. 5" 3. 5 inch double-sided drive; 2. 88M byte capacity. Floppy 3 Mode Support (for Japan Area) Disabled Drive A Drive B Both Normal Floppy Drive. Enable both Drive A and B 3 M ode support. Halt on The category determines whether the computer will stop if an error is detected during power up. All Errors Whenever the BIOS detects a non-fatal error the system will stop. No Errors The system boot will not stop for any error that m ay be detected and you will be prompted. All, But Keyboard The system boot will not stop for a keyboard error; it will stop for all other errors. (Default value) All, But Diskette The system boot will not stop for a disk error; it will stop for all other errors. All, But Disk/Key The system boot will not stop for a keyboard or disk error; it will stop for all other errors. Memory The category is display-only which is determ ined by POST (Power On Self Test) of the BIOS. Base Memory The POST of the BIOS will determine the amount of base (or conventional) m emory installed in the system. The value of the base m em ory is typically 512K for systems with 512K m em ory installed on the motherboard, or 640K for systems with 640K or m ore memory installed on the motherboard. Extended Memory The BIOS determines how much extended memory is present during the POST. This is the am ount of mem ory located above 1 M B in the CPU's memory address map. Total Memory This item displays the memory size that used. 8I845GE-RZ Series Motherboard - 24 - Advanced BIOS Features CMOS Setup Utility-Copyright (C) 1984-2004 Award Software Advanced BIOS Features First Boot Device Second Boot Device Third Boot Device Boot Up Floppy Seek Password Check CPU Hyper-Threadingno te Init Display First Graphics Aperture Sizeno te Graphics Share Memoryno te 4 3 1 2 English [Floppy] [HDD-0] [CDROM] [Disabled] [Setup] [Enabled] [Enabled] [Onboard/AGP] [128MB] [8M] Item Help Menu Level } Select Boot Device Priority [Floppy] Boot from floppy Limit CPUID Max. to 3not e [LS120] Boot from LS120 [HDD-0] Boot from First HDD [HDD-1] Boot from second HDD higf : Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults Note 1: This option appears only when the Intel Pentium ® 4 processor you install on the system supports the Hyper-Threading Technology. Note 2: This option is available only when you install an Intel® Prescott processor Note 3/4: This option is available only when you use the onboard VGA function. First / Second / Third Boot Device Floppy LS120 HDD-0~3 SCSI CDROM ZIP USB-FDD USB-ZIP USB-CDROM USB-HDD LAN Disabled Select your Select your Select your Select your Select your Select your Select your Select your Select your Select your Select your Select your boot device priority by Floppy. boot device priority by Disabled. Boot Up Floppy Seek During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. Disabled BIOS will not search for the type of floppy disk drive by track number. [. . . ] Support : http://www. giga-byte. com/TechSupport/ServiceCenter. htm Non-Tech. Support (Sales/Marketing) : http://ggts. gigabyte. com. tw/nontech. asp WEB address : http://www. giga-byte. com -- Germany G. B. T. TECHNOLOGY TRADING GMBH Address: Friedrich-Ebert-Damm 112 22047 Hamburg TEL: +49-40-2533040 (Sales) +49-1803-428468 (Tech. ) FAX: +49-40-25492343 (Sales) +49-1803-428329 (Tech. ) Tech. Support : http://de. giga-byte. com/TechSupport/ServiceCenter. htm Non-Tech. [. . . ]