User manual GEMINI CS-02

[. . . ] In the USA: If you experience problems with this unit, please go to http://www. Gemini stands behind their products with a 1 year limited warranty on all audio products. Parts of the design of this product may be protected by worldwide patents. Information in this manual is subject to change without notice and does not represent a commitment on the part of the vendor. [. . . ] GROUND LIFT SWITCH (56): This switch lifts the signal ground, and may help in the event of a stubborn ground loop issue. Using the GROUND LIFT SWITCH is in no way a substitute for proper wiring, but in a live scenario, it can help to eliminate ground hum. Before changing the position of the switch, make sure to turn the unit Off. If both `GND' and `LIFT' settings sound identical, then keep the switch set to `GND'. Turning the control clockwise increases the high frequencies, while turning the control counterclockwise decreases. In the middle position (the rotary control is detented here), there is no change being made to the audio signal. Turning the control clockwise increases the midrange frequencies, while turning the control counterclockwise decreases. In the middle position (the rotary control is detented here), there is no change being made to the audio signal. Turning the control clockwise increases the low frequencies, while turning the control counterclockwise decreases. In the middle position (the rotary control is detented here), there is no change being made to the audio signal. MIC 1 EFX ASSIGN BUTTON (6): This button assigns the audio signal of Microphone #1 to the DSP EFX section found on this mixer. When the LED on this button is illuminated, it indicates that the signal is being fed through the DSP. When the LED on this button is extinguished, it indicates that the signal is being output as-is, without any effect. MIC 1 ON/OFF/TALKOVER SWITCH (7): This switch determines whether Microphone #1 will be on, off, or on with Talkover. When talkover is engaged, the level of the audio (except for the microphone) will be attenuated so that the microphone can be easily heard over any music that may be playing. DEVICE/CHANNEL ASSIGN KNOB (8): This control, which is found on each mixer channel, determines which set of jacks will be used to drive that channel. Printed next to the knob itself is a diagram showing the positions and available devices that can be assigned to the channel. This feature allows many devices to be connected, 5 of which can be used simultaneously when they are selected using the DEVICE/CHANNEL ASSIGN KNOBs. CHANNEL GAIN CONTROL (9): These controls, found on each mixer channel, allow you to increase or decrease the volume of each channel. This is useful for matching levels during mixing, Or to make additional signal boosts when the CHANNEL VOLUME FADERS (22) do not provide enough. To match levels while mixing, visually match the level of the CHANNEL LED VU METERS (23), by making adjustments to the CHANNEL GAIN CONTROLS. CHANNEL HIGH BAND EQ (10): This rotary control, found on each channel, alters the amount of high frequency that is applied to the corresponding channel. [. . . ] attach the limiting plate to the new replacement X-Fader (model RG-45 or RG-45PRO). Then, replace the connector which plugs into the bottom of the fader, and replace the fader in the appropriate direction before screwing it back in. USER REPLACEABLE PARTS: User replaceable parts are listed below, and may be obtained by calling your nearest Gemini office, listed on the back cover page of this manual. 44 kg) Specifications and design are subject to change without notice for purpose of improvement. [. . . ]