User manual GARMIN USB DATA CARD PROGRAMMER

[. . . ] Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The USB Data Card Programmer does not contain any user-serviceable parts. Unauthorized repairs or modifications could result in permanent damage to the equipment, and void your warranty and your authority to operate this device under Part 15 regulations. Thank you for choosing the Garmin® USB Data Card Programmer or the Garmin StreetPilot® III with Mini-USB Data Card Programmer. To get successful results from your new USB Data Card Programmer, take time to read through this user's manual in order to fully understand all of the operating procedures. [. . . ] SOME STATES/COUNTRIES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. Government is subject to restrictions as set forth in subparagraphs (c)(1)(ii) of The Rights in Technical Data and Computer Software clause at DFARS 252. 227-7013, or subparagraphs (c)(1) and (2) of the Commercial Computer Software - Restricted Rights at 48 CFR 52. 227-19, or clause 18-52-227-86 (d) of the NASA Supplement to the FAR, as applicable. 7. ) EXPORT CONTROLS: You agree not to export or re-export the Product to any country in violation of the export control laws of the United States of America. GENERAL: This License is the entire agreement between us, superseding any other agreement or discussions, oral or written, and may not be changed except by a signed agreement. This License shall be governed by and construed in accordance with the laws of the State of Kansas, United States of America. If any provision of this License is declared by a court of competent jurisdiction to be invalid, illegal, or unenforceable, such a provision shall be severed from the License and the other provisions shall remain in full force and effect. iii Introduction Features Mini Data Card Programmer Garmin Data Cards The USB Data Card Programmer utilizes Garmin Data Cards. Available in five sizes: 8 MB Data Card 16 MB Data Card 32 MB Data Card 64 MB Data Card 128 MB Data Card Check the Garmin web site or see your Garmin dealer for availability of these data cards. USB Connector 6 Ft. USB Data Cable Data Card Slot (accepts only Garmin Data Cards) Data Card Programmer iv Installation of the USB Programmer and Device Drivers 1. Insert either the USB Data Card Programmer CD-ROM, MapSource City Navigator CD-ROM, or MapSource Setup CD into your computer's CD-ROM drive. It is important you insert the CD before you plug the USB Programmer into the PC!Connect the USB connector on the end of the Programmer cable to the USB port on the back of the computer. The computer does not need to be turned off when connecting or disconnecting the Programmer. After connecting the Programmer to your computer you will need to install the device drivers from the CD-ROM. The computer will recognize the Programmer as a USB (or unknown) device and open the Add New Hardware Wizard and search for the device drivers. If, for some reason, the Wizard does not run automatically, click the Start button and select "Settings" and then "Control Panel". The next screen will ask you if you want it to search for the best driver for your device or if you want to display a list to choose from. Select "Search for the best driver for your device" and click on "Next". The next screen will display a list of locations to search for the new drivers. The Wizard will search for the driver and then display a window to tell you it is ready to install. You may see a "Copying Files. . . " screen which tells you the file cannot be found. Choose Root Directory of the CD-ROM drive if not already there, and to try copying again (example d:\). Click "OK" to continue. Use care to insert the USB connector correctly. [. . . ] USB Port on your computer is not properly configured. Be certain the Programmer has been properly connected to your computer. When properly inserted, the card will protrude approximately 1/2 inch from the slot. Update MapSource software from the Garmin web site. System operating software is not USB When preparing to transfer data, a "No compatible device available. " message compatible. When preparing to transfer data, a "There No Data Card has been inserted in the is no data card in the Programmer. " mes- Programmer. [. . . ]