User manual GARMIN GPS 17 X NMEA 0183 HVS INSTALLATION GUIDE

[. . . ] When drilling or cutting, always check what is on the opposite side of the surface. If you experience difficulty installing the unit, seek the assistance of a professional installer or contact Garmin Product Support by phone at 913/397. WARNING: See the Important Safety and Product Information guide in the product box for product warnings and other important information. [. . . ] Make sure the large gasket is in Rubber place on the bottom of the GPS 17x Surface-mount gasket antenna, place the antenna on the bracket surface-mount bracket , and twist Seal pad it clockwise to lock it in place . Secure the antenna to the mounting surface bracket with the included M3 set screw . Route the power/data cable away from sources of electronic interference, and connect it to power and a NMEA 0183-compliant device. With the pole-mount adapter attached to the GPS 17x, you can install the GPS 17x on a standard 1 in. oD pipe-threaded-pole marine mount (14 threads per inch--not included). You can run the power/data cable through the pole or outside the pole. Route the power/data drop cable through the pole-mount adapter, and place the cable in the vertical slot along the base of the pole-mount adapter. (Optional) With the GPS 17x installed on the pole mount, fill the remaining gap in the vertical cable slot with a marine sealant. Route the cable away from sources of electronic interference, and connect it to power and a NMEA Vertical cable 0183-compliant device (page 4). (Optional) With the GPS 17x installed on the pole mount, fill the vertical cable slot with a marine sealant. Route the cable away from sources of electronic interference, and connect it to power and a NMEA 0183-compliant device (page 4). The GPS 17x can be mounted under a fiberglass surface with the included adhesive pads. The GPS 17x will not acquire satellite signals through metal--you can only use the under-deck mount under a fiberglass surface. Use extreme care to ensure that the screws do not penetrate the upper surface of the deck. Route the cable away from sources of electronic interference, and connect it to power and a NMEA 0183-compliant device (page 4). You can connect up to three NMEA 0183-compliant devices to receive data from one GPS 17x NMEA 0183 HVS antenna. If your NMEA 0183-compliant device has only one receiving wire (Rx), connect it to the gray wire (Tx/A) from the GPS 17x antenna, and leave the white/red wire (Tx/B) from the antenna unconnected. If your NMEA 0183-compliant device has only one transmitting wire (Tx), connect it to the white wire (Rx/A) from the GPS 17x antenna, and connect the white/orange wire (Rx/B) to ground. [. . . ] You agree not to export or re-export the Software to any country in violation of the export control laws of the United States of America. Materialtjocklek (tum) från 1/32 till 5/64 från /32 till /8 Materialtjocklek (mm) från 0, 76 till 2, 03 från 2, 28 till 9, 52 Led kabeln bort från källor till elektroniska störningar och anslut den till en strömkälla och en NMEA 0183Lodrät kompatibel enhet (sida 46). Led kabeln bort från källor till elektroniska störningar och anslut den till en strömkälla och en NMEA 0183-kompatibel enhet (sida 46). [. . . ]