User manual FBII LEGEND-100

[. . . ] The digits 0 - 9 are clearly marked and are used to enter your access code to control the Security System. 8- PULL OPEN DOOR The front of the keypad contains a door which pulls open. Behind this door is a card which can be filled out to describe the areas protected (zones) of your Security System. 4 r5 *-/ LED KEYPAD LAYOUT \ 14 7 1- ZONE STATUS The indicator lights marked 1-16 display the current status of the zones connected to your LEGEND Security System. [. . . ] This mode would be used when arming the system and you might be walking through protected interior zones. 12--BYPASS Key The BYPASS key will be used to temporarily turn off protection of a portion of your burglary protection. This could be performed, for example, to ignore an open window which would prevent the arming of your system. 13- INSTANT Key The INSTANT key is used to activate (arm) the system and eliminates the entry delay. This would cause an immediate alarm if someone came through an exit/entry zone. 14- CODE Key Function key used when entering or changing the User access codes of your system. INSTANT STAY CODE [USER] * # + 6 5 ARMING THE SYSTEM ARMING the system will activate all portions of your Security System. SYSTEM READY The system is ready to be armed if the READY indicator light located in the display portion of the keypad is ON. If the system is ready, ARMING can be performed as follows; ARMING PROCEDURE 1. Enter your four digit user code into the keypad: [USER] The ARMED indicator light will now be lit and if you are leaving the home you may exit through a door designated by your installer as an exit/entry zone for a fixed time period known as the exit delay. SYSTEM NOT READY If the system is not ready to be armed the READY indicator will be OFF. Zones can be bypassed if the user performing the bypass is authorized to perform bypasses and the zone has been defined by your installer as bypassable. If the zone has already been bypassed, the sequence will unbypass the zone except if the system is armed and the unbypassed zone is still not ready. After the bypass (or unbypass) command has been accepted the unit will emit a continuous beep and zone or zones that have been bypassed will appear in a slow blinking mode in the zone status area. Note: Bypassing can be performed either while the system is >> armed or disarmed. 10 INSTANT - STAY The INSTANT STAY mode will arm the system with the characteristics of both the INSTANT and STAY modes. The system will be armed with the interior portions bypassed and the entry delay will be suspended. PROCEDURE INSTANT STAY [USER] STAY INSTANT [USER] Depress the INSTANT and STAY keys in any order followed by your user code. After a sucessful INSTANT STAY arming the ARMED, INSTANT and STAY indicators will be lit. 9 To immediately arm the system enter [USER] after the last zone bypass. DISARMING Disarming the security system will deactivate the burglary portions of the system. IF NO ALARMS HAVE TAKEN PLACE Upon disarming the ARMING indicator will go off. The system display will reflect the current status. FORCED ARMING Forced Arming is a method that will automatically bypass all zones that are not ready and ARM the system. FORCED ARMING PROCEDURE; BYPASS [USER] BYPASS Depress the BYPASS key followed by your user code and the BYPASS key. [. . . ] NOTE: The DURESS capability is only available if activated by your installer. Please contact your installer to determine whether duress has been activated and the method used. I \ / / i Keypad Condition 1 The keypad emergency conditions are programmable and can be used for conditions such as PANIC, FIRE, or MEDICAL Emergency. These conditions can be programmed by your installer to suit your needs. The keypad emergency conditions are active 24 hours a day, whether the system is armed or disarmed. [. . . ]