User manual DRAKE DIGITAL DDA5542R

[. . . ] All implied warranties, if any, including warranties of merchantability and fitness for a particular purpose, terminate one (1) year from the date of the original purchase. The foregoing constitutes R. L. DRAKE COMPANY'S entire obligation with respect to this product, and the original purchaser shall have no other remedy and no claim for incidental or consequential damages, losses or expenses. Some states do not allow limitations on how long an implied warranty lasts or do not allow the exclusions or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. [. . . ] The gain adjustment range is limited and will not correct for unequal signal levels between channels in the same band. Establishing relatively equal signal levels between channels is essential. The Slope control permits sloping the overall frequency response to compensate for the effect of increasing signal loss of the higher frequency signals in a length of connected coaxial cable. TM is a trademark of the R. L. Drake Company P/N: 3852724B-9-2004 Printed in Taiwan 2 CAUTION STATEMENTS WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE THIS PRODUCT'S AC ADAPTER OR AMPLIFIER TO RAIN OR MOISTURE. Alternate Warnings--If this product is equipped with a three-wire grounding-type plug, a plug having a third (grounding) pin, the plug will only fit into a groundingtype power outlet. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Mise à la terre ou Polarisation--Cet appareil est équipé avec un cordon d'alimentation à trois fils. Power-Cord Protection--Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. Outdoor Antenna Grounding--If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Lightning--For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. Power Lines--An outside antenna system should not be located in the vicinity of overhead power lines, other electric light or power circuits, where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them may be fatal. Overloading--Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. Object and Liquid Entry--Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Servicing--Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Damage Requiring Service--Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. If liquid has been spilled, or objects have fallen into the product, c. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation, e. When the product exhibits a distinct change in performance--this indicates a need for service. [. . . ] This product should not be placed in a built-in installation such as bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. Power Sources--This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions. [. . . ]