User manual DIRT DEVIL TURBOCAT RUGRAT

[. . . ] This locked position is convenient for storage and for lifting of the Powerhead. To release wand from the vertical locked position, gently place foot on Powerhead, grasp wand and pull back firmly. (B) OPERATING PROCEDURES Your Turbine Powerhead has no on/off switch. Whenever it is attached to an operating vacuum system, it will be running. [. . . ] NOTE: The housing and supports are marked L and R and must be assembled accordingly. The ARROWS on the shaft supports must point toward the rear of the unit, when fitting a new belt. The supports can be rotated to point the arrows forward to increase belt tension after extensive use (typically several hundred hours of use). Place the lower belt shroud into the housing, over top of the brush pulley, as shown in FIG. Ensure that the top of the shroud cylindrical portion is flush with the upper housing screw boss. Stretch the bumper around the housing, over the shaft supports and press the bumper into place. Pull the belt gently up against the pulley teeth, and over the idler bearing. Twist the end of the belt 90° as illustrated on the lower housing and press the belt over the teeth of the drive shaft. NOTE: The brush will rotate in the wrong direction and belt damage may occur if the belt is twisted incorrectly. Tilt baseplate to the rear of brush area and insert the three tabs into the mating slots in the lower housing. Rotate the front of the base down so it seats into the groove in the bumper. Replace the belt cover as described in procedure ‘C’. Page 3 Page 4 INSTRUCTIONS FOR HAND HELD TURBINE POWERHEAD (A) ATTACHING THE HAND HELD TURBINE POWERHEAD To attach your metal wand and/or curved hose handle simply twist into hand brush neck until it fits snugly. To detach wand or curved hose handle, simply hold neck of Hand Held Powerhead and pull apart with a twisting motion. (B) OPERATING PROCEDURES Your hand held Turbine Powerhead has no on/off switch. Whenever it is attached to an operating vacuum system, it will be running. Slide the control valve open to reduce suction for cleaning draperies. 2) (C) CLEANING BRUSH Turn off vacuum system and disconnect Powerhead Brush. [. . . ] CHECK BOTTOM PLATE CHECK BELT AND TENSION CHECK BEATER BRUSH CHECK ALL INTAKE AREAS FOR OBSTRUCTIONS AND BRUSH ROTATION DIRECTION PAGE/PAR. FLOOR HAND BRUSH BRUSH 3/(E) 3/(C)(D) 3/(E) 3/(E) 3/(E) 4/(F) 2/(C) 3/(D) CENTRAL VACUUM CLEANER SYSTEMS 1. NON-BAG MODEL CHECK DIRT RECEPTACLE CHECK GUARD SCREEN CHECK ALL FILTER SCREENS CHECK HOSES FOR AIR LEAKS OR OBSTRUCTIONS 1. [. . . ]