User manual DIRT DEVIL ELECTROGLIDE REV 03-00

[. . . ] · Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow. · Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. · Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. [. . . ] Slide attachments firmly on handle as needed. Wand Assembly Attachments To remove wands from the Electroglide Powerhead, lock wands in straight up position. Press easy release pedal with foot and pull the wands straight up out of the Electroglide Powerhead. The Electroglide plug and cord do not have to be removed to use attachments on the wands. Put attachments on wands as needed. Wand Easy Release Pedal Caution: Do not attach or remove handle or wands while cleaner is ON. This could cause sparking and damage the electrical contacts. ELECTROGLIDE 7 PERFORMANCE FEATURES Edge Cleaner Active brush edge cleaners are on both sides of the Electroglide. Therefore, guide either side of the Electroglide along baseboards or next to furniture to help remove dirt trapped at carpet edges. Overload Protector The Electroglide has built-in protection against motor and belt damage should the brush jam. If the brush slows down or stops, the overload protector button pops up and shuts off the Electroglide automatically, while the power unit motor continues to run. To reset the system, just push in the overload protector button. Suction Control The suction control allows you to easily change the vacuum suction for different fabric and carpet weights. Opening the control decreases suction for drapes and lightweight rugs, while closing the control increases suction for upholsteries and carpets. Decrease Suction Increase Suction Handle Release Pedal The handle release pedal allows you to lower the wand and handle for extended and easier reach under furniture. Handle Release Pedal 8 ELECTROGLIDE MAINTENANCE AND CARE WARNING Always unplug electrical cord and vacuum hose before servicing and maintaining the Electroglide Electric Powerhead. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. Always follow all safety precautions specified when caring for your Electroglide. Light Bulb Replacemnent 1. Remove light cover by pressing in and lifting both sides of cover as shown. Push In And Turn 3. Close light cover until it snaps in place. Brush Cleaning Check the brush roll and brush support areas frequently in order to maintain optimum efficiency. If hair, string, thread, carpet fiber or lint becomes wound around the brush roll, remove by unwinding them by hand or carefully cutting with scissors. If buildup becomes excessive, disconnect the Electroglide Powerhead from the wand assembly and follow the Brush Replacement steps on Page 11. Instructions can also be found under the light cover. ELECTROGLIDE 9 MAINTENANCE AND CARE Belt Removal and Replacement The belt should also be checked periodically to be sure it is in good condition. If the belt needs replaced, use only Electroglide Belt # 7960. To remove belt: 1. Tilt cover forward from back until front snaps free. Easy Release 3. [. . . ] warrants that the Electroglide Electric Powerhead, when used in a commercial application, pursuant to Seller's instructions, will be free from defects in materials and workmanship for a period of ninety (90) days from the date of the initial sale by H-P PRODUCTS, INC. This warranty is limited to the replacement of defective parts and any costs of shipping shall be incurred by the purchaser. THIS WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS, IMPLIED, OR STATUTORY, AND H-P PRODUCTS, INC. [. . . ]